Husqvarna 16 manual Transport

Page 12

SAFETY INSTRUCTIONS

•Never use the machine indoors or in spaces lacking proper ventilation. Exhaust fumes contain carbon monoxide, an odourless, poisonous and highly dangerous gas.

•Stop and inspect the equipment if you run over or into anything. If necessary, make repairs before starting.

•Never make adjustments with the engine running.

•The machine is tested and approved only with the equipment originally provided or recommended by the manufacturer.

•The blades are sharp and can cause cuts. Wrap the blades or wear protective gloves when handling them.

•Check regularly that the parking brake works. Adjust and maintain as required.

8010-060

Never run the machine in an enclosed area.

• The mulching unit should only be used where
better quality mowing is required and in known
areas.
• Reduce the risk of fire by removing grass, leaves
and other debris that may have fastened on the
machine. Allow the machine to cool before
putting it in storage.
Transport
• The machine is heavy and can cause serious
crush injuries. Be especially careful when it is
loaded in or out of a car or on and off of a trailer.
• Use an approved trailer to transport the ma-	8010-061

chine. Activate the parking brake, shutoff the fuel	Regularly clean grass, leaves and other debris from the
supply and secure the machine using approved	machine.
fasteners, such as tension belts, chains or ropes
when transporting.

•Check and observe local road traffic regulations before transporting or driving the machine on roads.

IMPORTANT INFORMATION

The parking brake is not sufficient to lock the machine during transport. Ensure you secure the machine firmly to the transporting vehicle. Reverse the machine on to the transporting vehicle to prevent it from overturning.

10 – English

Image 12

Contents Rider Svenska Contents Instruction Dear customerTravel and transport on public roads TowingSafety Instructions Good serviceSerial number Engine TransmissionExplanation of Symbols Safety instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Cutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval HoursDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Ignition systemInspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Belt change on BioClip6016-111 Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin BioClip Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Trouble Shooting Schedule Problem ProcedureService StorageWinter storage Technical Data EU-DECLARATION of Conformity EU declaration of conformity Only applies to EuropeServicejournal Rider Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00