Husqvarna 16 manual Adjusting the parallelism of the cutting unit, Removing the cutting unit

Page 32

MAINTENANCE

Adjusting the parallelism of the cutting unit

1.Remove the front hood and right-hand fender, as described on page 21.

2.Undo the nuts on the lift strut.

3.Unscrew the strut (anticlockwise) to lower the rear edge of the hood.

Screw the strut in (clockwise) to raise the rear edge of the hood.

4.Tighten the nuts after adjustment.

5.On completion of the adjustment the unit’s parallelism should be re-checked.

6.Fit the right-hand fender and the front hood.

Removing the cutting unit

WARNING!

Wear protective glasses when dismantling the cutting unit. The spring which tensions up the belt can go off and cause personal injury.

1.Carry out points 1-9 to put the cutting unit in the service position, see “Service position for the cutting unit” on page 33.

2.Remove the bolt (3) and lift off the cutting unit.

Fitting of the cutting unit takes place in the reverse order to removal. See page 28 for details of how to fit the BioClip 90.

When assembling: Make sure that the unit’s “lug” enters the loop correctly on the underside of the machine.

6017-018

2

1

3

6017-021

8009-123

30 – English

Image 32

Contents Rider Svenska Contents Instruction Dear customerTravel and transport on public roads TowingSafety Instructions Good serviceSerial number Engine TransmissionExplanation of Symbols Safety instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Cold engine DrivingStarting the engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval HoursDismantling of the machine hoods Engine hoodFront hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Ignition systemInspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeObserve caution to avoid trapping your hand Installing BioClipFitting the cutting unit Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Belt change on BioClip6016-111 Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin BioClip Removal of BioClip plug CombiChanging the oil LubricationCheck the engine’s oil level General lubrication Lubricating the belt adjusterCheck the transmission’s oil level Trouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Technical Data EU-DECLARATION of Conformity EU declaration of conformity Only applies to EuropeServicejournal Rider Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00