Husqvarna 16 manual 6017-221 6017-222 8009-122 6017-223

Page 36

MAINTENANCE

4.Fit the support wheels on either side of the rear of the cutting unit.

WARNING!

Wear protective glasses when dismantling the cutting unit. The spring which tensions up the belt can go off and cause personal injury.

5.Disengage the spring from the drive belt tensioning wheel.

6.Move the cutting height lever to the lower position.

7.Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut. Engage the strut in the holder.

6017-221

6017-222

8009-122

6017-223

34 – English

Image 36

Contents Rider Svenska Contents Instruction Dear customerTravel and transport on public roads TowingSafety Instructions Good serviceSerial number Engine TransmissionExplanation of Symbols Safety instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Cutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval HoursDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Ignition systemInspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Belt change on BioClip6016-111 Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin BioClip Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Trouble Shooting Schedule Problem ProcedureService StorageWinter storage Technical Data EU-DECLARATION of Conformity EU declaration of conformity Only applies to EuropeServicejournal Rider Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00