Husqvarna 16 manual Driving, Starting the engine, Cold engine

Page 17

DRIVING

•Read the safety instructions and information on the location and function of the controls before starting (see pages 5-14).

•Conduct daily maintenance before starting (see maintenance schedule on page 20).

Adjust the seat to the required position.

Starting the engine

1.Lift up the cutting unit by pulling the lever backwards to locked position (transport posi- tion).

2.Apply the parking brake. This is done as follows:

•Press down the brake pedal (1).

•Press in the lock button on the steering column (2).

•Release the brake pedal while the button is held pressed.

The parking brake lock disconnects automati cally when the brake pedal is pressed down.

6007-001H

2

1

Cold engine:

3.Push the throttle control to position 3 (choke position). In this position the engine receives a richer mixture so that the engine starts more easily.

		6017-011
	1	2
	1	3
		3
		6007-004H
		English – 15

Image 17

Contents Rider Svenska Contents Dear customer InstructionTravel and transport on public roads TowingGood service Safety InstructionsSerial number Engine TransmissionExplanation of Symbols General use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Lift lever for cutting unit Cutting unitFuelling Lever for adjustment of cutting heightSeat Cold engine DrivingStarting the engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterProcedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Ignition systemInspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureObserve caution to avoid trapping your hand Installing BioClipFitting the cutting unit Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt change on BioClip Replacing the cutting unit belts6016-111 Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClipChanging the oil LubricationCheck the engine’s oil level General lubrication Lubricating the belt adjusterCheck the transmission’s oil level Problem Procedure Trouble Shooting ScheduleWinter storage ServiceStorage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityPre-delivery service Servicejournal RiderAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00