Husqvarna 16 manual Explanation of Symbols

Page 6

EXPLANATION OF SYMBOLS

These symbols are on the machine and in the operator’s manual.

Study them carefully so that you know what they mean.

Read the operator’s manual

R N

Reverse

Neutral

Fast

Slow

Engine off

Battery

Choke

Fuel

Oil pressure

Cutting height

Backwards

Forwards

Ignition

Hydrostatic free wheel

Use eye and hearing protection

Parking brake

Brake

Warning

Noise emission to surroundings in accordance	Warning!	Warning!	Never drive across a	CE conformity
with the directive of the European Community.	Rotating blades.	Risk that the	slope	marking
The machine’s emission is indicated in the		machine can tip over
chapter TECHNICAL DATA and on the decal.

Never use the machine if persons, especially	Never carry passengers on the
children, or animals, are in the vicinity.	machine or equipment.

Starting instructions Read the instructions Check the engine’s oil level Check the hydrostat’s oil level Lift up the cutting unit

Put the hydrostat pedals in the neutral position

Brake

If the engine is cold use the choke Start the engine

Release the parking brake before driving

Keep hands and feet away	Drive very slowly
from under the hood when	without the cutting unit.
the engine is running.

Speed limiter pedal forwards

Neutral

Speed limiter pedal reverse

Switch off the engine and take off the ignition cable before repairs or maintenance

4 – English

Image 6

Contents Rider Svenska Contents Travel and transport on public roads InstructionDear customer TowingSerial number Safety InstructionsGood service Engine TransmissionExplanation of Symbols Safety instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Cutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidProcedures on contact with acid Ignition systemInspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Belt change on BioClip6016-111 Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin BioClip Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Trouble Shooting Schedule Problem ProcedureService StorageWinter storage Technical Data EU-DECLARATION of Conformity EU declaration of conformity Only applies to EuropeAfter first 5 hours Servicejournal RiderPre-delivery service Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00