Husqvarna 16 manual Driving the machine

Page 19

DRIVING

Driving the machine

1.Release the parking brake by pressing down the brake pedal.

6017-012

2.	Carefully press down one of the pedals until the	2	1
	correct speed is reached.		1
	correct speed is reached.
	To drive forwards: press down pedal (1).
	To reverse: press down pedal (2).
			6017-214A

3. Select the required cutting height (1-9) with the

cutting height lever.

To obtain a uniform cutting height it is important

that the tyre pressures are equal on both front

wheels (60 kPa).

6007-008H

English – 17

Image 19

Contents Rider Svenska Contents Towing InstructionDear customer Travel and transport on public roadsEngine Transmission Safety InstructionsGood service Serial numberExplanation of Symbols General use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Lift lever for cutting unit Cutting unitSeat Lever for adjustment of cutting heightFuelling Starting the engine DrivingCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineHours MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Dismantling of the machine hoodsEngine hood Front hoodAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterIgnition system Check the level of the battery acidProcedures on contact with acid Checking of the fuel pump’s air filterInspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureFitting the cutting unit Installing BioClipObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt change on BioClip Replacing the cutting unit belts6016-111 Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClipCheck the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityWork done Date, mileage, stamp, sign Servicejournal RiderPre-delivery service After first 5 hoursServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00