Husqvarna 16 manual Stopping the engine, Release lever

Page 21

DRIVING

WARNING!

Never drive the machine on ground with a slope of more than 15°. Mow slopes upwards and downwards, never across. Avoid sudden changes in direction.

Stopping the engine

Preferably allow the engine to idle for a minute to obtain normal working temperature before stopping it if it has been working hard.

1.Lift up the cutting unit by pulling the lever back to the end position.

2.Pull back the throttle control and turn the ignition key to the STOP position.

3. When the Rider is at a standstill, press down the

parking brake and push in the locking button.

Release lever

The release control must be pulled out in order for the Rider to be moved when the engine is shutoff.

MAX 15

	6007-002
	6007-014H
STOP	START
	6007-015

6007-217H

English – 19

Image 21

Contents Rider Svenska Contents Dear customer InstructionTravel and transport on public roads TowingGood service Safety InstructionsSerial number Engine TransmissionExplanation of Symbols General use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Lift lever for cutting unit Cutting unitLever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterProcedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Ignition systemInspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureInstalling BioClip Fitting the cutting unitObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt change on BioClip Replacing the cutting unit belts6016-111 Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClipLubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Problem Procedure Trouble Shooting ScheduleService StorageWinter storage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityPre-delivery service Servicejournal RiderAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00