Husqvarna 16 manual Safety Instructions, Good service, Serial number, Engine Transmission

Page 5

SAFETY INSTRUCTIONS

Good service

Husqvarna products are sold all over the world and only through servicing dealers. This is to ensure that you, the customer, get the best support and service. Before the machine is delivered it undergoes inspection and is adjusted by your dealer.

When you need spare parts or advice on service issues, warranty terms, etc., contact:

This Operator’s Manual belongs to machine with serial number:

Engine

Transmission

Serial number

The serial number can be found on the printed plate attached to the front, left-hand side under the seat. Stated on the plate, from the top are:

•The machines type designation.

•The manufacturer’s type number.

•The machine’s serial number.

State the type designation and serial number when ordering spare parts.

The engine number is punched on a plate that is riveted to the fan cover. The plate states:

•Model.

•Type.

•Code.

Please state these when ordering spare parts.

The transmission’s serial number is stated on the barcode decal located on the front of the housing on the left-hand drive axle:

•Type designation is stated above the barcode and starts with the letter “K”.

•The serial number is stated above the barcode and has the prefix “s/n”.

•The manufacturer’s type number is stated under the barcode and has the prefix “p/n”. State the type designation and serial number when ordering spare parts.

English – 3

Image 5

Contents Rider Svenska Contents Dear customer InstructionTravel and transport on public roads TowingGood service Safety InstructionsSerial number Engine TransmissionExplanation of Symbols General use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Lift lever for cutting unit Cutting unitFuelling Lever for adjustment of cutting heightSeat Cold engine DrivingStarting the engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterProcedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Ignition systemInspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureObserve caution to avoid trapping your hand Installing BioClipFitting the cutting unit Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt change on BioClip Replacing the cutting unit belts6016-111 Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClipChanging the oil LubricationCheck the engine’s oil level General lubrication Lubricating the belt adjusterCheck the transmission’s oil level Problem Procedure Trouble Shooting ScheduleWinter storage ServiceStorage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityPre-delivery service Servicejournal RiderAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00