Husqvarna 16 manual Checking and adjustment of the throttle wire, Replacement of the fuel filter

Page 25

MAINTENANCE

Checking and adjustment of the throttle wire

If the engine does not respond as it should do when the throttle lever is moved or if the top speed is not reached, the throttle wire may need adjusting.

1.Loosen the clamping screw (by the arrow), and slide the throttle to the choke position.

2.Pull the throttle wire’s casing as far as possible to the right and check that the choke is fully actuated.

3.Tighten the clamping screw.

4.Pull back the throttle to the full throttle position and check that the choke is no longer actuated.

Replacement of the fuel filter

Replace the pipe fitted fuel filter every 100 running hours (once per season) or more frequently if it is clogged.

Replace the filter as follows:

1.Fold open the engine cover as described on page 19.

2.Move the hose clips away from the filter. Use a pair of flat pliers.

3.Pull off the filter from the hose ends.

4.Press in the new filter on the hose ends. If necessary soap solution can be applied on the filter ends to simplify fitting.

5.Push the hose clips back on the filter.

6008-032

6008-033

8009-108

6008-034

English – 23

Image 25

Contents Rider Svenska Contents Dear customer InstructionTravel and transport on public roads TowingGood service Safety InstructionsSerial number Engine TransmissionExplanation of Symbols General use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Lift lever for cutting unit Cutting unitSeat Lever for adjustment of cutting heightFuelling Starting the engine DrivingCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterProcedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Ignition systemInspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureFitting the cutting unit Installing BioClipObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt change on BioClip Replacing the cutting unit belts6016-111 Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClipCheck the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityPre-delivery service Servicejournal RiderAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00