Husqvarna 16 manual Fitting the cutting unit, Installing BioClip

Page 30

MAINTENANCE

Fitting the cutting unit

1.Place the Rider on a flat surface and apply the parking brake. Check that the lever for setting the cutting height is in the lowest position.

Make sure the support wheels are fitted to the cutting unit (1).

2.Grasp the handle at the front (BioClip 90) or hold the frame of the cutting unit (2) and slide the unit underneath the rider mower, making sure that the tongue on the cutting unit (3) engages correctly.

3.Insert the bolt and secure it with a locking pin.

WARNING!

Observe caution to avoid trapping your hand.

4.Press down the frame and insert the pin. Fit the drive belt around the drive wheels of the cutting unit.

5.Hook up the height adjustment strut.

6.Fit the front cover.

7.Secure the collet’s spring, see ring in the diagram below.

Installing BioClip 90

In order to install BioClip 90 the drive belt support wheel must first be removed.

1.Release the tensioning wheel’s spring, see ring in the diagram.

2.Remove the locking pin (1) that is located next to the support wheel.

3.Screw off the nut and washer (2) under the centre of the support wheel. Remove the screw and support wheel.

4.Fit the cutting unit according to the instructions above.

3

1

2

6017-159

6017-120

6017-160

1

2

9

6017-142

28 – English

Image 30

Contents Rider Svenska Contents Travel and transport on public roads InstructionDear customer TowingSerial number Safety InstructionsGood service Engine TransmissionExplanation of Symbols Safety instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Cutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidProcedures on contact with acid Ignition systemInspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitObserve caution to avoid trapping your hand Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Belt change on BioClip6016-111 Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin BioClip Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Trouble Shooting Schedule Problem ProcedureService StorageWinter storage Technical Data EU-DECLARATION of Conformity EU declaration of conformity Only applies to EuropeAfter first 5 hours Servicejournal RiderPre-delivery service Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00