Husqvarna 16 manual Dismantling of the machine hoods, Engine hood, Front hood, Right-hand fender

Page 23

MAINTENANCE

Dismantling of the machine hoods

Engine hood

The engine is accessible for servicing when the engine hood is lifted up.

Tilt the seat forward, release the rubber strap under the seat, and tilt the hood backwards.

6008-001

Front hood

Release the clip on the front hood and lift off the fender.

Right-hand fender

Remove the knob (1), the screws (2 and 3) and lift off the hood.

6017-215

3

2

11

6017-003

Left-hand fender

Release the screws in the fender (2) and lift off the fender.

6017-013

English – 21

Image 23

Contents Rider Svenska Contents Towing InstructionDear customer Travel and transport on public roadsEngine Transmission Safety InstructionsGood service Serial numberExplanation of Symbols General use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Lift lever for cutting unit Cutting unitFuelling Lever for adjustment of cutting heightSeat Cold engine DrivingStarting the engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineHours MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Dismantling of the machine hoodsEngine hood Front hoodPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterIgnition system Check the level of the battery acidProcedures on contact with acid Checking of the fuel pump’s air filterInspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureObserve caution to avoid trapping your hand Installing BioClipFitting the cutting unit Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt change on BioClip Replacing the cutting unit belts6016-111 Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClipChanging the oil LubricationCheck the engine’s oil level General lubrication Lubricating the belt adjusterCheck the transmission’s oil level Problem Procedure Trouble Shooting ScheduleWinter storage ServiceStorage Technical Data EU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityWork done Date, mileage, stamp, sign Servicejournal RiderPre-delivery service After first 5 hoursServicejournal Servicejournal Servicejournal ´+H$¶6k¨ Page 114 00