Husqvarna 155, 155 AWD manual General Maintenance

Page 16

SAFETY INSTRUCTIONS

General Maintenance

Never operate machine in a closed area.

Keep all nuts and bolts tight to be sure the equipment is in safe working condition.

Never tamper with safety devices. Check their proper operation regularly.

Keep machine free of grass, leaves, or other debris build-up. Clean oil or fuel spillage and remove any fuel-soaked debris. Allow machine to cool before storing.

If you strike a foreign object, stop and inspect the machine. Repair, if necessary, before restar- ting.

Never make any adjustments or repairs with the engine running.

Check grass catcher components and the discharge guard frequently and replace with manufacturer’s recommended parts, when necessary.

Mower blades are sharp. Wrap the blade or wear gloves, and use extra caution when servicing them.

Check brake operation frequently. Adjust and service as required.

Maintain or replace safety and instruction labels, as necessary.

Do not modify safety equipment. Check regularly to be sure it works properly. The machine must not be driven with defective or unmounted protective plates, protective cowlings, safety switches, or other protective devices.

Do not change the settings of governors and avoid running the engine with overly high engine speeds. If you run the engine too fast, you risk damaging the machine components.

Be very careful when handling battery acid. Acid on skin can cause serious corrosive burns. If you spill battery acid on your skin, rinse immediately with water.

WARNING!

The battery contains lead and lead compounds, chemicals that are considered to cause cancer, birth defects, and other reproductive system damage. Wash your hands after handling the battery.

8010-060

Never run the machine in an enclosed area.

14 – English

Image 16
Contents Rider 155 Rider 155 AWD Page Contents Introduction Manufacturing Number Good ServiceEngine Transmission Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Safe handling of gasolineTowing of the machine Travel and transport on public roadsIntended use Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxxPlacards Safety Instructions Safety InstructionsSafety Instructions Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controlsSpeed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for the cutting unitSeat Lever for adjustment of cutting heightRefueling Operation Before startingStarting the engine Cold engineWarm engine To start an engine with a weak battery To remove cables, reverse orderRunning Moving tips Stopping the engine MAX1015Rear Axle Release leverFront Axle Maintenance Maintenance scheduleCleaning and washing Avoid using a high pressure washer or a steam cleanerDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWDAdjusting the throttle wire Inspecting the mufflerReplacement of the fuel filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidIgnition system Fitting the wrong spark plug type can damage the engineChecking the safety system Checking the tire pressure Main fuseCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitPlacing in service position Service position for the cutting unitBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the bladesRemoval of BioClip plug Combi Check the engine’s oil level LubricationChanging the oil Change of oil filter Check the transmission’s oil levelLubricating the belt adjuster General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Technical Data Servicejournal Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01