Husqvarna 155, 155 AWD manual Checking and adjustment of the steering wires

Page 34

MAINTENANCE

Checking and adjustment of the steering wires

The steering is controlled by means of wires.

These can in time become slack, which implies that the adjustment of the steering becomes altered.

Check and adjust the steering as follows:

1.Dismantle the frame-plate by releasing the screws (two on each side).

2.Check the tension of the steering wires by pushing them together as shown in the dia- gram. It should be possible to push them together so that the distance between them is half as much, without using unnecessary force.

3.If necessary, the wires can be adjusted by tightening the adjuster nuts on each side of the steering collar. Do not tension the wires too much, they should only be tightened against the steering collar.

Support the wire so it does not twist.

If you tension only one side the steering wheel’s centre position may change.

Check the wire tension as set out in point 2 after you have made the adjustment.

6008-008H

6008-009

6008-010

32 – English

Image 34
Contents Rider 155 Rider 155 AWD Page Contents Introduction Manufacturing Number Good ServiceEngine Transmission II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. ChildrenIV. Service Safe handling of gasolineTowing of the machine Travel and transport on public roadsIntended use Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxxPlacards Safety Instructions Safety InstructionsSafety Instructions Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controlsSpeed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for the cutting unitSeat Lever for adjustment of cutting heightRefueling Starting the engine OperationBefore starting Cold engineWarm engine To start an engine with a weak battery To remove cables, reverse orderRunning Moving tips Stopping the engine MAX1015Rear Axle Release leverFront Axle Maintenance Maintenance scheduleCleaning and washing Avoid using a high pressure washer or a steam cleanerFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWDAdjusting the throttle wire Inspecting the mufflerReplacement of the fuel filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidIgnition system Fitting the wrong spark plug type can damage the engineChecking the safety system Checking the tire pressure Main fuseCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitPlacing in service position Service position for the cutting unitBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the bladesRemoval of BioClip plug Combi Check the engine’s oil level LubricationChanging the oil Change of oil filter Check the transmission’s oil levelLubricating the belt adjuster General lubricationTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data Technical Data After first 5 hours ServicejournalPre-delivery service Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01