Husqvarna 155, 155 AWD manual Removal of BioClip plug Combi

Page 49

MAINTENANCE

Removal of BioClip plug (Combi)

To change a Combi unit from BioClip function to cutting unit with rear ejection, remove the BioClip plug located under the unit with three screws.

1.Put the unit in the service position, see "Placing in the service position".

2.Remove the three screws holding the BioClip plug, and remove the plug.

3.Tip: Fit three full-thread screws M8x15 mm in the screw holes to protect the threads.

4.Replace the unit in normal position.

Fit the BioClip plug in the reverse order.


	Service position	6017-227

Removal of BioClip plug

8009-289

English – 47

Image 49

Contents Rider 155 Rider 155 AWD Page Contents Introduction Manufacturing Number Good ServiceEngine Transmission General operation Safe operation practices for ride-on mowersII. Slope operation III. ChildrenSafe handling of gasoline IV. ServiceTowing of the machine Travel and transport on public roadsIntended use Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Explanation of Symbols and DecalsPlacards Safety Instructions Safety InstructionsSafety Instructions Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Location of the controls ControlsSpeed limiter Throttle and Choke leverParking brake Lift lever for the cutting unit Cutting unitSeat Lever for adjustment of cutting heightRefueling Before starting OperationStarting the engine Cold engineWarm engine To remove cables, reverse order To start an engine with a weak batteryRunning Moving tips MAX1015 Stopping the engineRear Axle Release leverFront Axle Maintenance schedule MaintenanceAvoid using a high pressure washer or a steam cleaner Cleaning and washingEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the Parking Brake Rider 155 AWD Adjusting the parking brakeInspecting the mufﬂer Adjusting the throttle wireReplacing the air filter Replacement of the fuel filterProcedures on contact with acid Check the level of the battery acidFitting the wrong spark plug type can damage the engine Ignition systemChecking the safety system Checking the tire pressure Main fuseCheck the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitChecking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitPlacing in service position Service position for the cutting unitBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Checking the blades Restoring from service positionRemoval of BioClip plug Combi Check the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Change of oil filterGeneral lubrication Lubricating the belt adjusterProblem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage CoverTechnical Data Technical Data Pre-delivery service ServicejournalAfter first 5 hours Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01