Husqvarna 155, 155 AWD manual Stopping the engine, MAX1015

Page 29

OPERATION

WARNING!

Never drive the machine on ground with a slope of more than 10°. Mow slopes upwards and downwards, never across. Avoid sudden changes in direction.

Operating on hills

Read the Safety Instructions “Driving on Slopes” in the “Safety Instructions”.

MAX1015

6017-247

•The slowest speed possible should be used before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If stopping is absolutely necessary engage the parking brake.

•To restart movement, release the parking brake.

•Make all turns slowly.

Stopping the engine

Preferably allow the engine to idle for a minute to obtain normal working temperature before stopping it if it has been working hard.

1.Lift up the cutting unit by pulling the lever back to the end position.

2.Pull back the throttle control and turn the ignition key to the STOP position.

3. When the Rider is at a standstill, press down the

parking brake and push in the locking button.

	6007-014H
STOP	START
	6007-015
	English – 27

Image 29

Contents Rider 155 Rider 155 AWD Page Contents Introduction Engine Transmission Good ServiceManufacturing Number General operation Safe operation practices for ride-on mowersII. Slope operation III. ChildrenSafe handling of gasoline IV. ServiceIntended use Travel and transport on public roadsTowing of the machine Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Explanation of Symbols and DecalsPlacards Safety Instructions Safety InstructionsSafety Instructions Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Location of the controls ControlsParking brake Throttle and Choke leverSpeed limiter Lift lever for the cutting unit Cutting unitRefueling Lever for adjustment of cutting heightSeat Before starting OperationStarting the engine Cold engineWarm engine To remove cables, reverse order To start an engine with a weak batteryRunning Moving tips MAX1015 Stopping the engineFront Axle Release leverRear Axle Maintenance schedule MaintenanceAvoid using a high pressure washer or a steam cleaner Cleaning and washingEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the Parking Brake Rider 155 AWD Adjusting the parking brakeInspecting the mufﬂer Adjusting the throttle wireReplacing the air filter Replacement of the fuel filterProcedures on contact with acid Check the level of the battery acidFitting the wrong spark plug type can damage the engine Ignition systemChecking the safety system Check the engine’s cooling air intake Main fuseChecking the tire pressure Observe caution to avoid trapping your hand Fitting the cutting unitChecking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt replacement on the cutting unit Service position for the cutting unitPlacing in service position Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Checking the blades Restoring from service positionRemoval of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Check the transmission’s oil level Change of oil filterGeneral lubrication Lubricating the belt adjusterProblem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage CoverTechnical Data Technical Data Pre-delivery service ServicejournalAfter first 5 hours Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01