Husqvarna 155, 155 AWD To start an engine with a weak battery, To remove cables, reverse order

Page 26

OPERATION

To start an engine with a weak battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged.

If “jumper cables” are used for emergency starting,
follow this procedure:
IMPORTANT INFORMATION
Your mower is equipped with a 12-volt
negative grounded system. The other
vehicle must also be a 12-volt negative
grounded system. Do not use your
mower battery to start other vehicles.
To attach jumper cables
• Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
• Connect one end of the BLACK cable to the
NEGATIVE (-) terminal of the fully charged
battery.
• Connect the other end of the BLACK cable to a
good CHASSIS GROUND, away from the fuel
tank and battery.
To remove cables, reverse order
• BLACK cable first from chassis and then from
the fully charged battery.
• RED cable last from both batteries.
Jumper cables connection	8011-642
Jumper cables connection

24 – English

Image 26

Contents Rider 155 Rider 155 AWD Page Contents Introduction Engine Transmission Good ServiceManufacturing Number II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. ChildrenIV. Service Safe handling of gasolineIntended use Travel and transport on public roadsTowing of the machine Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxxPlacards Safety Instructions Safety InstructionsSafety Instructions Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controlsParking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for the cutting unitRefueling Lever for adjustment of cutting heightSeat Starting the engine OperationBefore starting Cold engineWarm engine To start an engine with a weak battery To remove cables, reverse orderRunning Moving tips Stopping the engine MAX1015Front Axle Release leverRear Axle Maintenance Maintenance scheduleCleaning and washing Avoid using a high pressure washer or a steam cleanerFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWDAdjusting the throttle wire Inspecting the mufﬂerReplacement of the fuel filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidIgnition system Fitting the wrong spark plug type can damage the engineChecking the safety system Check the engine’s cooling air intake Main fuseChecking the tire pressure Fitting the cutting unit Observe caution to avoid trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitBelt replacement on the cutting unit Service position for the cutting unitPlacing in service position Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the bladesRemoval of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Change of oil filter Check the transmission’s oil levelLubricating the belt adjuster General lubricationTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data Technical Data After first 5 hours ServicejournalPre-delivery service Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01