Husqvarna 155, 155 AWD manual Controls, Location of the controls

Page 20

CONTROLS

Congratulations on your choice of a top quality product which you will enjoy for many years.

This operator’s manual describes Rider 155 and Rider 155 AWD. The machines are equipped with a 15.5 horse power engine from Kohler.

Rider 155 AWD also features all wheel drive.

The power transmission from the engine is handled

by a hydrostatic gearbox, which allows variable variation of the speed by using the pedals.

There is one pedal for driving forwards and one pedal for reversing.

Location of the controls			9.	Knobs for adjusting seat	xx
1.	Ignition lock	xx	10.	Fuel tank cap	xx
2.	Throttle/Choke lever	xx	11.	Lever to disengage the driving
3.	Adjustment of cutting height	xx		front axle 155 AWD	xx

4.	Lifting lever, cutting unit	xx	12.	Main lock (under seat)	xx

5.	Speed limiter for reversing	xx	13.	Lever for disengagement of
				drive Rider 155	xx
6.	Speed limiter for driving forwards	xx
				Lever to disengage the driving
7.	Parking brake	xx
				rear axle 155 AWD	xx

8.	Lock button for parking brake	xx

18 – English

Image 20

Contents Rider 155 Rider 155 AWD Page Contents Introduction Engine Transmission Good ServiceManufacturing Number Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Safe handling of gasolineIntended use Travel and transport on public roadsTowing of the machine Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxxPlacards Safety Instructions Safety InstructionsSafety Instructions Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controlsParking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for the cutting unitRefueling Lever for adjustment of cutting heightSeat Operation Before startingStarting the engine Cold engineWarm engine To start an engine with a weak battery To remove cables, reverse orderRunning Moving tips Stopping the engine MAX1015Front Axle Release leverRear Axle Maintenance Maintenance scheduleCleaning and washing Avoid using a high pressure washer or a steam cleanerDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWDAdjusting the throttle wire Inspecting the mufﬂerReplacement of the fuel filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidIgnition system Fitting the wrong spark plug type can damage the engineChecking the safety system Check the engine’s cooling air intake Main fuseChecking the tire pressure Fitting the cutting unit Observe caution to avoid trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitBelt replacement on the cutting unit Service position for the cutting unitPlacing in service position Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the bladesRemoval of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Change of oil filter Check the transmission’s oil levelLubricating the belt adjuster General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Technical Data Servicejournal Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01