Husqvarna 155, 155 AWD manual 8009-122 6017-223 6017-225 6017-226

Page 47

MAINTENANCE

6.Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut. Engage the strut in the holder.

WARNING!

Observe caution to avoid trapping your hand.

7.Lift off the drive belt (1). Then pull out the pin

(2).

8. Pull the frame forwards and refit the pin.

8009-122

6017-223

1

2

6017-225

6017-226

English – 45

Image 47

Contents Rider 155 Rider 155 AWD Page Contents Introduction Engine Transmission Good ServiceManufacturing Number III. Children Safe operation practices for ride-on mowersGeneral operation II. Slope operationSafe handling of gasoline IV. ServiceIntended use Travel and transport on public roadsTowing of the machine Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Explanation of Symbols and DecalsPlacards Safety Instructions Safety InstructionsSafety Instructions Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Location of the controls ControlsParking brake Throttle and Choke leverSpeed limiter Lift lever for the cutting unit Cutting unitRefueling Lever for adjustment of cutting heightSeat Cold engine OperationBefore starting Starting the engineWarm engine To remove cables, reverse order To start an engine with a weak batteryRunning Moving tips MAX1015 Stopping the engineFront Axle Release leverRear Axle Maintenance schedule MaintenanceAvoid using a high pressure washer or a steam cleaner Cleaning and washingRight-hand fender Dismantling of the machine hoodsEngine hood Front hoodChecking and adjustment of the steering wires Adjusting the Parking Brake Rider 155 AWD Adjusting the parking brakeInspecting the mufﬂer Adjusting the throttle wireReplacing the air filter Replacement of the fuel filterProcedures on contact with acid Check the level of the battery acidFitting the wrong spark plug type can damage the engine Ignition systemChecking the safety system Check the engine’s cooling air intake Main fuseChecking the tire pressure Observe caution to avoid trapping your hand Fitting the cutting unitChecking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt replacement on the cutting unit Service position for the cutting unitPlacing in service position Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Checking the blades Restoring from service positionRemoval of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Check the transmission’s oil level Change of oil filterGeneral lubrication Lubricating the belt adjusterProblem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data Technical Data Work done Date, mileage, stamp, sign ServicejournalPre-delivery service After first 5 hours´z+R23¶5L¨ Page 115 01