Husqvarna 155, 155 AWD manual Service position for the cutting unit, Placing in service position

Page 45

MAINTENANCE

Belt replacement on the cutting unit

On these cutting units with "collision-proof" blades, the blades are driven by one V-belt. Do as follows to change the V-belt:

1.Remove the cutting unit, see page 38.

2.Undo the bolt on the lift strut and the two screws on the cover. Lift the cover off the cutting unit.

3.Loosen the spring that tensions the V-belt and pry off the belt.

Simply reverse the procedure to fit the new belt.

Service position for the cutting unit

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In service position, the cutting unit is raised and locked in the vertical position.

Placing in service position

1.Position the machine on flat ground. Apply the parking brake (A). Adjust the cutting unit to the lowest cutting height and lower the cutting unit

(B).

2.Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood).

8009-287

6012-080

8009-437

6021-006

English – 43

Image 45

Contents Rider 155 Rider 155 AWD Page Contents Introduction Good Service Manufacturing NumberEngine Transmission General operation Safe operation practices for ride-on mowersII. Slope operation III. ChildrenSafe handling of gasoline IV. ServiceTravel and transport on public roads Towing of the machineIntended use Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Explanation of Symbols and DecalsPlacards Safety Instructions Safety InstructionsSafety Instructions Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Location of the controls ControlsThrottle and Choke lever Speed limiterParking brake Lift lever for the cutting unit Cutting unitLever for adjustment of cutting height SeatRefueling Before starting OperationStarting the engine Cold engineWarm engine To remove cables, reverse order To start an engine with a weak batteryRunning Moving tips MAX1015 Stopping the engineRelease lever Rear AxleFront Axle Maintenance schedule MaintenanceAvoid using a high pressure washer or a steam cleaner Cleaning and washingEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the Parking Brake Rider 155 AWD Adjusting the parking brakeInspecting the mufﬂer Adjusting the throttle wireReplacing the air filter Replacement of the fuel filterProcedures on contact with acid Check the level of the battery acidFitting the wrong spark plug type can damage the engine Ignition systemChecking the safety system Main fuse Checking the tire pressureCheck the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitChecking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitService position for the cutting unit Placing in service positionBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Checking the blades Restoring from service positionRemoval of BioClip plug Combi Lubrication Check the engine’s oil levelChanging the oil Check the transmission’s oil level Change of oil filterGeneral lubrication Lubricating the belt adjusterProblem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage CoverTechnical Data Technical Data Pre-delivery service ServicejournalAfter first 5 hours Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01