Husqvarna 155, 155 AWD manual Cleaning and washing

Page 32

MAINTENANCE

Cleaning and washing

Clean the machine directly after use.

It is much easier to wash off grass cuttings before they dry.

Oily dirt can be removed using a cold degreasing agent. Spray on a thin layer.

Rinse at normal water pressure.

Do not direct the jet towards electrical components or bearings.

Do not rinse hot surfaces, for example, the engine and exhaust system.

It is recommended that you start the engine and run the mower for a short period after cleaning, so that any remaining water is blown off.

Lubricate the machine if necessary after cleaning.

Carry out extra lubrication when the bearings have been exposed to a degreaser or a water jet.

IMPORTANT INFORMATION

Avoid using a high pressure washer or a steam cleaner

There is a major risk of water penetrating into bearings and electrical connections. Corrosion attack can result, which will lead to running problems. Cleaning additives generally aggravate the damage.

8009-741

30 – English

Image 32
Contents Rider 155 Rider 155 AWD Page Contents Introduction Engine Transmission Good ServiceManufacturing Number Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Safe handling of gasolineIntended use Travel and transport on public roadsTowing of the machine Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxxPlacards Safety Instructions Safety InstructionsSafety Instructions Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controlsParking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for the cutting unitRefueling Lever for adjustment of cutting heightSeat Operation Before startingStarting the engine Cold engineWarm engine To start an engine with a weak battery To remove cables, reverse orderRunning Moving tips Stopping the engine MAX1015Front Axle Release leverRear Axle Maintenance Maintenance scheduleCleaning and washing Avoid using a high pressure washer or a steam cleanerDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWDAdjusting the throttle wire Inspecting the mufflerReplacement of the fuel filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidIgnition system Fitting the wrong spark plug type can damage the engineChecking the safety system Check the engine’s cooling air intake Main fuseChecking the tire pressure Fitting the cutting unit Observe caution to avoid trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitBelt replacement on the cutting unit Service position for the cutting unitPlacing in service position Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the bladesRemoval of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Change of oil filter Check the transmission’s oil levelLubricating the belt adjuster General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Technical Data Servicejournal Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01