Husqvarna 155, 155 AWD manual Check the level of the battery acid, Procedures on contact with acid

Page 38

MAINTENANCE

5.The paper filter may be carefully tapped on a hard surface to remove dust. Do not try to wash or blow it with compressed air.

6.Insert the paper filter and check that it is correct sealed to its seat. Tighten the paper filter wing nut and install the precleaner over the paper filter.

7.Fit the air filter cover and tighten its wing nut.

Check the level of the battery acid

Always use protective glasses when handling the battery.

Check that the level of the battery acid lies between the markings. Top up the cells with only distilled water.

WARNING!

Procedures on contact with acid

External: Rinse well with plenty of water.

Internal: Drink large quantities of water or milk. Contact a doctor as soon as possible.

Eyes: Rinse well with plenty of water. Contact a doctor as soon as possible.

Batteries emit explosive gas. Sparks, flames and cigarettes must absolutely not be brought into the vicinity of the battery.

WARNING!

Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparks from accidental grounding.

8009-461

8009-462

6008-013

36 – English

Image 38

Contents Rider 155 Rider 155 AWD Page Contents Introduction Engine Transmission Good ServiceManufacturing Number II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. ChildrenIV. Service Safe handling of gasolineIntended use Travel and transport on public roadsTowing of the machine Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxxPlacards Safety Instructions Safety InstructionsSafety Instructions Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controlsParking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for the cutting unitRefueling Lever for adjustment of cutting heightSeat Starting the engine OperationBefore starting Cold engineWarm engine To start an engine with a weak battery To remove cables, reverse orderRunning Moving tips Stopping the engine MAX1015Front Axle Release leverRear Axle Maintenance Maintenance scheduleCleaning and washing Avoid using a high pressure washer or a steam cleanerFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWDAdjusting the throttle wire Inspecting the mufﬂerReplacement of the fuel filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidIgnition system Fitting the wrong spark plug type can damage the engineChecking the safety system Check the engine’s cooling air intake Main fuseChecking the tire pressure Fitting the cutting unit Observe caution to avoid trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitBelt replacement on the cutting unit Service position for the cutting unitPlacing in service position Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the bladesRemoval of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Change of oil filter Check the transmission’s oil levelLubricating the belt adjuster General lubricationTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data Technical Data After first 5 hours ServicejournalPre-delivery service Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01