Husqvarna 155, 155 AWD manual Maintenance schedule

MAINTENANCE

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For the items which are not described in these instructions go to an authorised service workshop.An annual service carried out by an authorized service workshop is recommended to maintain your machine in the best possible condition and to ensure safe operation.

Read “Maintenance” in the Safety Instructions section.

		Daily	At least	Maintenance interval
Maintenance	Page	mainte-	once		in hours
		nance	a year	25	50	100	200
		before start
Cleaning	27	●
Check the engine’s oil level	45	●
Check the engine’s cooling air inlet	36	●
Check the steering wires	29	●
Check the battery	33	●
Check the safety system	35	●
Check screws and nuts	–	❍
Check for fuel and oil leakage	–	❍
Clean around the silencer	–	❍
Check the silencer	31			●
Change the engine oil 1)	45			●1)	●1)
Replace the air filter’s prefilter 2)	32			●
Check the cutting unit	38			●
Check the tyre pressures 60 kPa//8.5 PSI	36			●
Lubricating the belt adjuster 3)	47			●
Lubricate joints and shafts 3)	47			●
Check the V-belts	–			❍
Check the hydrostat’s cooling fins	–			❍
Check the transmission’s oil level	46	●
Adjust the parking brakes	30				●
Check and adjust the throttle wire	31				●
Clean the engine’s and hydrostat’s cooling flanges 2,4)	–				❍
Replace the air filter’s pre-filter and paper filter 2)	32					●
Replace the fuel filter	32					●
Replace the plug	34					●
Check the need of an oil change 4,5) in
the gearbox/hydraulic system	–		❍				❍

1)First change after 5 hours. Replace after every 25 hours with heavy loads or high temperatures.2) During dusty conditions cleaning and replacement should be more frequent. 3) For daily use of the machine lubrication should be conducted twice a week. 4) Conducted by authorised service workshop.5) Rider 155 AWD only. Replace first after 8 hours.

●= Described in these instructions.

❍ = Not described in these instructions.

WARNING!

No service procedures must be conducted on the engine or cutting unit unless:

•The engine is switched off.

•The ignition key is removed.

•The ignition cable is removed from the plug.

•The parking brake is applied.

•The cutting unit is disengaged.

Note: Specific written instructions shall be provided with the equipment for servicing operations, recommended by the manufacturer, that shall be performed with the engine running.

English – 29