Husqvarna 155, 155 AWD manual Lubricating the belt adjuster, General lubrication

Page 52

LUBRICATION

Lubricating the belt adjuster

The belt adjuster should be lubricated regularly using good quality molybdenum disulphide grease*.

1 nipple from the right-hand side under the engine’s lower belt pulley, until grease is forced out.

With daily use lubrication should be conducted twice a week.

General lubrication

All joints and bearings are lubricated on manufacture with molybdenum sulphide grease. Re-grease with same type of grease*. Lubricate the steering and control wires with engine oil.

The machine should be lubricated regularly, and twice a week when used daily.

*Grease from well-known brand names (petrol companies, etc.) usually maintains a good quality. The most important property is that the grease provides good protection against corrosion.

6008-232

50 – English

Image 52

Contents Rider 155 Rider 155 AWD Page Contents Introduction Manufacturing Number Good ServiceEngine Transmission Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Safe handling of gasolineTowing of the machine Travel and transport on public roadsIntended use Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxxPlacards Safety Instructions Safety InstructionsSafety Instructions Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controlsSpeed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for the cutting unitSeat Lever for adjustment of cutting heightRefueling Operation Before startingStarting the engine Cold engineWarm engine To start an engine with a weak battery To remove cables, reverse orderRunning Moving tips Stopping the engine MAX1015Rear Axle Release leverFront Axle Maintenance Maintenance scheduleCleaning and washing Avoid using a high pressure washer or a steam cleanerDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWDAdjusting the throttle wire Inspecting the mufﬂerReplacement of the fuel filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidIgnition system Fitting the wrong spark plug type can damage the engineChecking the safety system Checking the tire pressure Main fuseCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitPlacing in service position Service position for the cutting unitBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the blades Removal of BioClip plug Combi Check the engine’s oil level LubricationChanging the oil Change of oil filter Check the transmission’s oil levelLubricating the belt adjuster General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Technical Data Servicejournal Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01