Husqvarna 155, 155 AWD Adjusting the parking brake, Adjusting the Parking Brake Rider 155 AWD

Page 35

MAINTENANCE

Adjusting the parking brake

The parking brake is adjusted as follows:

1.Loosen the locking nuts (1).

2.Tension the cable using the adjuster screw (2) until the play in the cable is taken up.

3.Tighten the locking nuts (1).

4.The parking brake should be checked again after the adjustment has been made.

WARNING!

A poorly adjusted parking brake can result in reduced braking ability and cause an accident.

6008-239H

Adjusting the Parking Brake

Rider 155 AWD

Check that the parking brake is adjusted correctly by placing the machine on a slope with the front and rear axles disengaged. Apply and lock the parking brake. When the machine does not stand still, the parking brake should be adjusted accord- ing to the following.

1.Remove the left-hand wing cover.

2.Loosen the locking nuts (1).

3.Tension the cable using the adjuster screw (2) until the play in the cable is taken up.

4.Tighten the locking nuts (1).

5.The parking brake should be checked again after the adjustment has been made.

6.Assemble the left-hand wing cover.

WARNING!

A poorly adjusted parking brake can result in reduced braking ability and cause an accident.

8009-501

6021-031

English – 33

Image 35

Contents Rider 155 Rider 155 AWD Page Contents Introduction Engine Transmission Good ServiceManufacturing Number III. Children Safe operation practices for ride-on mowersGeneral operation II. Slope operationSafe handling of gasoline IV. ServiceIntended use Travel and transport on public roadsTowing of the machine Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Explanation of Symbols and DecalsPlacards Safety Instructions Safety InstructionsSafety Instructions Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Location of the controls ControlsParking brake Throttle and Choke leverSpeed limiter Lift lever for the cutting unit Cutting unitRefueling Lever for adjustment of cutting heightSeat Cold engine OperationBefore starting Starting the engineWarm engine To remove cables, reverse order To start an engine with a weak batteryRunning Moving tips MAX1015 Stopping the engineFront Axle Release leverRear Axle Maintenance schedule MaintenanceAvoid using a high pressure washer or a steam cleaner Cleaning and washingRight-hand fender Dismantling of the machine hoodsEngine hood Front hoodChecking and adjustment of the steering wires Adjusting the Parking Brake Rider 155 AWD Adjusting the parking brakeInspecting the mufﬂer Adjusting the throttle wireReplacing the air filter Replacement of the fuel filterProcedures on contact with acid Check the level of the battery acidFitting the wrong spark plug type can damage the engine Ignition systemChecking the safety system Check the engine’s cooling air intake Main fuseChecking the tire pressure Observe caution to avoid trapping your hand Fitting the cutting unitChecking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitBelt replacement on the cutting unit Service position for the cutting unitPlacing in service position Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Checking the blades Restoring from service positionRemoval of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Check the transmission’s oil level Change of oil filterGeneral lubrication Lubricating the belt adjusterProblem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data Technical Data Work done Date, mileage, stamp, sign ServicejournalPre-delivery service After first 5 hours´z+R23¶5L¨ Page 115 01