Husqvarna 155, 155 AWD manual Cutting unit, Lift lever for the cutting unit

Page 22

CONTROLS

Cutting unit

Rider 155 and Rider 155 AWD are equipped with a cutting unit.

Combi

- 1030 mm/41"

See ”Maintenance \ Checking the Blades” for identification of the cutting unit.

6017-214

Lift lever for the cutting unit

The lift lever is used to set the cutting unit in trans- port or cutting position.

If the lever is pulled back the unit will lift up and the blades will automatically stop rotating (transport position).

If the lock button is pressed and the lever is moved forward the unit will be lowered and the blades will automatically start rotating (cutting position).

	The lever can also be used to temporarily regulate
	the cutting height, e.g. for a small mound in the
	lawn.	6004-011H
	Lifting of the cutting unit (transport position)	6004-011H
	Lifting of the cutting unit (transport position)

6004-012H

Lowering of the cutting unit (cutting position)

20 – English

Image 22

Contents Rider 155 Rider 155 AWD Page Contents Introduction Manufacturing Number Good ServiceEngine Transmission II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. ChildrenIV. Service Safe handling of gasolineTowing of the machine Travel and transport on public roadsIntended use Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxxPlacards Safety Instructions Safety InstructionsSafety Instructions Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controlsSpeed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for the cutting unitSeat Lever for adjustment of cutting heightRefueling Starting the engine OperationBefore starting Cold engineWarm engine To start an engine with a weak battery To remove cables, reverse orderRunning Moving tips Stopping the engine MAX1015Rear Axle Release leverFront Axle Maintenance Maintenance scheduleCleaning and washing Avoid using a high pressure washer or a steam cleanerFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWDAdjusting the throttle wire Inspecting the mufﬂerReplacement of the fuel filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidIgnition system Fitting the wrong spark plug type can damage the engineChecking the safety system Checking the tire pressure Main fuseCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitPlacing in service position Service position for the cutting unitBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the bladesRemoval of BioClip plug Combi Check the engine’s oil level LubricationChanging the oil Change of oil filter Check the transmission’s oil levelLubricating the belt adjuster General lubricationTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data Technical Data After first 5 hours ServicejournalPre-delivery service Work done Date, mileage, stamp, sign´z+R23¶5L¨ Page 115 01