ASSEMBLY
Continued
9.Turning chain tensioning screw, adjust posi- tion of adjustment block until it is aligned and inserted into the round adjusting hole on guide bar (see Figures 7 and 8). Turning screw coun- terclockwise will move adjustment block to rear of guide bar. Turning screw clockwise will move adjustment block to front of guide bar.
10.If needed, readjust guide bar nut to finger tight only.
11.Adjust saw chain tension. Follow steps under Saw Chain Tension Adjustment, pages 8 and 9.
WARNING:Maintainproperchainten- sion always. A loose chain will increase the risk of kickback. A loose chain may jump out of guide bar groove. This may injure operator and damage chain. A loose chain will cause chain, guide bar, and sprocket to wear rapidly.
IMPORTANT!
Failure to follow these instructions when tensioning saw chain will damage saw and void the warranty. For additional information call
| Adjusting Hole |
Slot | Guide Bar Bolt |
|
New saw chains will stretch. Check chain tension frequently when first used and tighten when chain becomes loose around guide bar.
|
| Step |
| ❶ |
|
|
|
|
| 2 |
|
|
|
|
|
Step | Bushing |
|
|
|
|
| |
1 |
|
|
|
|
| ||
|
|
|
|
|
|
| |
Sprocket Cover Tab | Guide Bar Nut |
|
|
|
|
| |
|
|
|
|
|
| ||
Figure 7 - Installing Sprocket Cover |
|
|
|
|
| ||
|
|
|
| If chain becomes loose around guide | |||
Chain Tensioning |
|
|
| bar, allow chain to cool then... | |||
Screw |
|
|
|
|
|
|
|
Adjustment Block |
|
|
| ❷ |
|
|
|
Figure 8 - Chain Tensioning Screw and |
|
|
|
|
| ||
Adjustment Block Location |
|
|
| O |
| ||
|
|
|
|
|
| ||
|
|
|
| O | S | ||
|
|
|
| L |
| ||
SAW CHAIN TENSION |
|
|
|
| E | ||
|
|
|
| N | |||
ADJUSTMENT |
|
|
|
|
|
|
|
WARNING: Unplug chain saw from |
|
|
|
|
| ||
power source before adjusting saw chain |
|
|
|
|
| ||
tension. |
|
|
|
|
|
|
|
WARNING: Cutting edges on chain |
| Loosen nut... |
|
|
| ||
are sharp. Use protective gloves when |
|
|
|
| |||
handling chain. |
|
|
|
|
|
|
|
www.desatech.com |
|
| 8 |
|
|
| 113005 |