RedMax BCZ2650T, BCZ2650SS manual Fuel, Gasoline Requirements, OIL Requirements, Warranty

Page 12

BCZ2650S/T/SS

7. Fuel

FUEL

lines or fuel tank of the engine.

WARNING

Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10 ft (3 m) away from the fueling point before starting the engine.

GASOLINE REQUIREMENTS

• All 2-Stroke RedMax Products are powered by Zenoah Professional-Commercial Duty, Hi-Performance, Hi-RPM, Air Cooled 2-Stroke engines.

RedMax/Zenoah – Hi-Performance 2-stroke engines produce higher HP outputs as compared to standard Home Owner Duty or Light Commercial Duty production engines offered by most manufacturers.

• Exhaust emission are controlled by the fundamental engine parameters and components (eq., carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion.

• The RedMax/Zenoah Engines are registered and certified with CARB (California Air Resources Board) and EPA (Environmental Protection Agency) to operate on CLEAN Mid- grade 89 octane or Premium, unleaded (lead-free) gasoline and RedMax Air-Cooled "Max Life", Synthetic blend Premium two- stroke engine oil mixed at 50:1 ratio.

• Unleaded gasoline is recommended to reduce the contamination of the air for the sake of your health and the environment.

• This Hi-Performance Air Cooled 2-stroke Engine requires the

use of Minimum 89 Octane [ R+M ] (Mid grade or Premium) 2

clean gasoline. Gasoline may contain maximum of 10% Ethanol (grain alcohol) or up to 15% MTBE (Methyl tertiary-butyl ether). Gasoline containing Methanol (Wood Alcohol) is NOT approved.

NOTE

IF octane rating of the Mid Grade gasoline in your area is lower than 89 Octane use Premium Unleaded Gasoline. The majority of all 2-stroke engine manufacturers in the USA and Canada recommend using gasoline with 89 Octane or higher.

NOTE

Failures caused by operating engines on gasoline with octane rating lower than 89 are not covered by the RedMax Two- Stroke engine warranty.

WARNING

Alternative Fuels (Not Gasoline)

Alternative fuels, such as E-15 (15% ethanol), E-20 (20% ethanol), E-85 (85% ethanol) are NOT classified as gasoline and are NOT approved for use in RedMax 2-stroke gasoline engines. Use of alternative fuels will cause major engine performance and durability problems such as: improper clutch engagements, overheating, vapor lock, power loss, lubrication deficiency, deterioration of fuel lines, gaskets and internal carburetor components, etc... Alternative fuels cause high moisture absorption into the fuel/oil mixture leading to oil and fuel separation.

OIL REQUIREMENTS

Use only RedMax "Max Life", Synthetic blend Premium Air- Cooled two-stroke engine oil or oil certified to ISO-L-EGD (ISO/CD1378) standard AND one that is JASO-FD registered. RedMax Air-Cooled "Max Life", Synthetic blend Premium two stroke engine oil and ISO-L-EGD (ISO/CD1378) AND JASO-FD oils are fully compatible with gasoline's containing 10% Ethanol. RedMax Air-Cooled "Max Life", Synthetic blend Premium two stroke engine oil and ISO-L-EGD (ISO/CD1378) AND JASO-FD oils are Universal and should be mixed at 50:1 ratio for all 2 stroke air cooled engines sold in the past regardless of mixing ratios specified in those manuals.

If the oil is registered with JASO, the JASO Logo with FD and registration number will be displayed on the container. The highest JASO rating is "FD", which equals the ISO-L-EGD rating. Lower ratings are "FC", "FB", and "FA".

Engine problems due to inadequate lubrication caused by failure to use ISO-L-EGD certified and JASO FD registered oil such as "MaxLife", RedMax Synthetic blend Premium 2-stroke oil WILL VOID THE REDMAX TWO-STROKE ENGINE

WARRANTY.

WARNING

Gasoline with an octane rating lower than 89 will greatly increase the engines operating temperature. Low octane gasoline will cause detonation (knock) resulting in piston seizures and major internal engine components damage.

Poor quality gasolines or oils may damage sealing rings, fuel

US-10

WARNING

Do not use NMMA (National Marine Manufacturers Association), BIA (Boating Industry Association), and TCW (two cycle water cooled) oils designed for MoPeds or Outboard, water cooled Marine Engines. Do not use API (American Petroleum Institute), TC (Two Cycle) labeled oils. The API-TC

Image 12
Contents BCZ2650S BCZ2650T / BCZ2650SS Page OWNERS/OPERATORS S Manual Contents Specifications Parts locationSymbols on the machine Emission ControlManufactured For safe operation Using the product Before useStarting the engine Fuel safety Avoid noise problemMaintenance TransportDisposal Set up Installing HandleSE2 Installing Debris Guard SE3 Installing Line Head SE3Warranty FuelFuel Gasoline RequirementsHOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OIL For Your Engine LIFE, AvoidFueling the Unit Operation Adjusting the Line Length Cutting Work Line Head UsageTrimming Grass and Weeds OP7Maintenance Maintenance ChartFor safety reasons, do not use metalreinforced line MA1 Refilling Trimming Line MA1Replacement Plug is a NGK CMR7H Muffler MA2AIR Filter MA3MA8 Procedures to be Performed After Every 100 Hours of USE StorageDisposal MA7Optional blade usage for BCZ2650S only OPT6 OPT7 OPT8 Starting the EngineCutting Method OperationMaintenance Blade How you can maintain the best controlOPT10 22, 24-tooth blade Tooth blade Point OPT10Troubleshooting guide Case 1. Starting failureCheck Probable Causes Action Mode D’EMPLOI Differents Types D’AVERTISSEMENT DE CE Mode D’EMPLOI Tables des matieresEmplacement des pieces BCZ2650S/BCZ2650T/BCZ2650SS Dimensions totales L x L x HFiche technique Symboles utilises sur la machine Etiquettes d’avertissement sur la machineMesures DE Lutte Contre LES Emissions Consignes de securite Avant DE Faire Demarrer LE Moteur Demarrage DU MoteurUtilisation DU Produit Transport Sécurité carburantRangement Comment eviter les nuisances sonoresLes doigts morts il est fortement recommandé de Mise au rebutEntretien SE3 Installation DE LA Tete DE FIL SE3 AssemblageMise EN Place DE LA Poignee SE2Carburant CarburantTypes DE Carburants Requis ’ANNULATION DE LA Garantie DU Moteur a Deux Remplissage DU ReservoirEviter Pour Prolonger LA Duree DE VIE DU Moteur FR-12 Fonctionnement OP7 Travail DE Coupe Utilisation DE LA Tete DE FIL Coupe DE Gazon OU D’HERBESReglage DE LA Longeur DU FIL DE Coupe MA1 Remplacement DU FIL DE Coupe MA1 EntretienTableau D’ENTRETIEN Silencieux MA2 Filtre a AIRFiltre a Carburant PARE-ETINCELLESRangement Mise au rebutCylindre Ouïe d’entrée d’air de refroidissement arrière Choisir LA Lame OPT3 OPT1 OPT2Mise EN Place DE LA Lame OPT5 Equilibrage DE LA MachineMethode DE Coupe FonctionnementControle DES Coups DE Recul Comment conserver le meilleur contrôle de la machine Entretien LameGuide de localisation des pannes Verification Causes Probables ActionPage Desbrozador Contenido Advertencias Contenidas EN EL ManualSituación de las piezas EspecificaciohesBCZ2650S/BCZ2650T/BCZ2650SS Etiqueta de advertencia en la máquina Símbolos presentes en la máquinaPosición Control DE EmisionesInstrucciones de seguridad Antes DE Arrancar LA Máquina Arranque DEL MotorCómo evitar problemas de ruido USO DEL ProductoTransporte Seguridad en el uso del combusiblePara la protección contra las vibraciones EliminaciónMantenimiento Montaje Combustible CombustibleRequerimientos de la Gasolina Anulará Lagarantía DEL Motor DE DOS Tiempos RedMax Preste atención en la agitaciónAbastecimiento DE LA Unidad Para Contribuir a LA Vida Útil DEL MOTOR, EviteVacíe del carburador el combustible compuesto Uso Cómo Parar EL Motor OP3Ajuste Cable DEL Acelerador Ajuste DE LA Velocidad DE Marcha EN Vacío OP6OP7 Trabajo DE Corte USO DEL Cabezal DE Hilo Desbroce DE Hierbas Y MalezaAjuste DE LA Longitud DE LA Línea Mantenimiento Tabla DE MantenimientoMA1 Rellenado DE LA Línea DE Desbroce MA1 Filtro DE Aire MA2 SilenciadorMA3 Filtro DE Combustible ParachispasAlmacenamiento EliminaciónMA8 Procedimientos a Realizar Cada 100 Horas DE USO Cilindro Toma de aire de refrigeración posteriorUso de hoja opcional sólo para BCZ2650S Elija LA HojaPAR Torsor Monte LA HojaMétodo DE Corte USOControl DEL Contragolpe DE LA Hoja Qué causa el contragolpeCómo se puede reducir la posibilidad de contragolpe? Cuál es la mejor forma de mantenerMantenimiento Hoja Punto OPT1013. Guía de localización y solución de problemas Comprobar Posibles Causas AcciónPage Parts list RemarqueNota Drive Unit BCZ2650S S/N 90200101 and up Optional Blade & Accessories Part Number Description QtyKey# Part Number Description Qty Drive Unit BCZ2650T/SS S/N 90200101 and up Optional Accessories Key# Part Number DescriptionEngine Unit BCZ2650S/T/SS S/N 90200101 and up Cylinder Page Page Zenoah AMERICA, INC