TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
Lines will not advance when using the Auto Feed Head:
1.Lines are welded to themselves.
2.Not enough string on spool.
3.Lines are worn too short.
4.Lines are tangled on spool.
1.Lubricate with silicone spray.
2.Install more line. Refer to Line Replacement earlier in this manual.
3.Pull both lines while pressing button.
4.Remove lines from spool and rewind. Refer to Line Replacement earlier in this manual.
Grass wraps around driveshaft 1. Cutting tall grass at ground level. | 1. Cut tall grass from the top down to prevent |
housing and string head: | wrapping. |
Motor fails to start when switch trigger is depressed.
1. | Power cord is not plugged in or | 1. | Plug in the power cord. |
| connection is loose. |
|
|
2. | Household circuit breaker is | 2. | Check circuit breaker. |
| tripped. |
|
|
| CALL |
|
CALL US FIRST
For any questions about operating or maintaining your product,
call the Homelite® Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
Page 11 — English