Craftsman D25083, 919.672240 owner manual Source on to remove all air, From the hose. When there

PROBLEM		CAUSE		CORRECTION
No or low	6.	Air in hose.	6.	Turn off the engine, then
pressure				the water source.
(initial use)				Disconnect the water
(continued)				source from the pump
				inlet and turn the water
				source on to remove all air
				from the hose. When there
				is a steady stream of
				water present, turn water
				source off. Reconnect
				water source to pump inlet
				and turn on water source.
				Squeeze trigger to remove
				remaining air.
	7.	Choke lever in the	7.	Move choke to the "No
		"Choke" position.		Choke" position.
	8.	Throttle control lever is	8.	Move throttle control lever
		not in the "Fast" position.		to the "Fast" position.
	9.	High pressure hose is too	9.	Use high pressure hose
		long.		under 100 feet.
Will not draw	1.	Wand not in low	1.	See How to Use Wand
chemicals		pressure.		paragraph in the
				Operation Section.
	2.	Chemical filter clogged.	2.	Clean filter.
	3.	Chemical screen not in	3.	Insure end of chemical
		chemical		hose is fully submerged
				into chemical.
	4.	Chemical too thick	4.	Dilute chemical. Chemical
				should be the same con-
				sistency as water.
	5.	Pressure hose is too long	5.	Lengthen water supply
				hose instead of pressure
				hose.
	6.	Chemical build up in	6.	Have parts cleaned or
		chemical injector.		replaced by AWSC.

D25083 20- ENG