Craftsman D25083, 919.672240 owner manual Storage, Engine Preparation, Peratures are Expected

Page 18

STORAGE

ENGINE

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as the carbure- tor, fuel filter, hose or tank during stor- age. Also, experience indicates that al- cohol-blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel sys- tem of an engine while in storage. To avoid engine problems, the fuel sys- tem should be emptied before storage of 30 days or longer. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Engine Preparation

•First add a fuel stabilizer to the fuel tank.

•Run pressure washer for a full 5 minutes to allow fuel stabilizer to enter the fuel system.

While preparing the engine make sure

water supply is turned on and flow- ing to the unit. NEVER run unit without water supply running through pump. Failure to do so will cause pump damage.

•Next shut off engine and discon- nect the water supply.

•Disconnect the spark plug wire and remove the spark plug.

•Add one teaspoon of oil through the spark plug hole.

•Place rag over spark plug hole and pull the recoil a few times to lubricate the combustion cham- ber.

•Replace the spark plug, but do not connect the spark plug wire.

PUMP

It is recommended that you follow these steps to protect the internal seals of the pressure washer when storing the unit for an extended period and WHEN FREEZING TEM-

PERATURES ARE EXPECTED.

NOTE: If storing the unit for more than 30 days RV antifreeze or wind- shield washer fluid needs to be run through the pump. This helps pre- vent damage within the pump head. RV antifreeze or windshield washer fluid is not only added for winteriz- ing, but for proper lubrication regardless of temperature or envi- ronment. Storing the pump less than 30 days does not require the RV antifreeze or windshield washer fluid.

1.Obtain a funnel, six ounces of RV antifreeze or windshield washer fluid, and approximately 12 inches of garden hose with a male hose connector attached to one end.

Use only RV antifreeze. Any

other antifreeze is corrosive and can damage pump.

2.Disconnect spark plug wire.

3.Disconnect high pressure hose from pump and from spray gun.

4.Connect 12 inch length of hose to water inlet of pump.

5.Add RV antifreeze or windshield washer fluid to hose as shown.

D25083

18- ENG

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Pressure Washer Table of Contents Specification Chart Safety Guidelines DefinitionsRisk of Explosion or Fire Important Safety InstructionsHazard Risk to BreathingRisk of Unsafe Operation Risk of Electrical ShockSpray directed at electrical outlets or Risk to Fluid Injection Risk of Chemical BurnRisk of HOT Surfaces BOX Contents AssemblyRemove Loosen Engine OperationPressure Washer Throttle Control Lever Controls engine speedTo Adjust Pressure Pressure Washer TerminologyTo USE Wand To Siphon CHEMICALS/CLEANING Solvents To Shut DownBefore Starting Maintenance Engine Maintenance TaskCustomer Responsibilities Table Pressure WasherCleaning To Change OilInspect Clean and Replace Spark Plug PumpWand Storage Engine PreparationPeratures are Expected Troubleshooting Guide Problem Cause CorrectionWater source to pump inlet From the hose. When thereSource on to remove all air High pressure hose is tooProblem Cause Correction ENG HOW to Order Service and Repair PartsGuide de l’utilisateur Table DES Matières GarantieDe modèle 919.672240 Laveuse à pression Tableau DES SpécificationsMesures DE Sécurité Définitions MoteurMesures DE Sécurité Importantes Risque DE Feux OU DexplosionRisque PAR Inhalation Risque Dune Utilisation NON Sécuritaire Risque DE Chocs ÉlectriquesRisque Dinjection DUN Fluide Risque DE Brûlures ChimiquesRisque DE Surfaces Chaudes Des brûlures gravesContenu DE LA Boîte AssemblageRetirer Desserer Laveuse À Pression UtilisationFamiliarisez-vous avec votre laveuse à pression MoteurRéglage DE LA Pression Terminologie DES Laveuses À PressionUtilisation Utilisation DE LA LanceArrêt DE LA Laveuse À Pression Siphonnage DE Produits CHIMIQUES/SOLVANTS DE NettoyageAvant LE Démarrage Ouvrez le robinet de la source deauEntretien « OFF »Tache D’ENTRETIEN MoteurTableau DES Responsabilités DU Client Vérification du niveau d’huileInspection Changement de l’huileFiltre à air NettoyageNettoyage et remplacement de la bougie d’allumage PompeBuse Entreposage Préparation du moteurGuide DE Dépannage Problème Cause CorrectionRetirez le boyau court de lorifice dentrée de la pompe 20- FR Csga = Centre de service sous garantie autorisé Tubes sont endommagés à Faire remplacer par un Cause du gel39- FR Pour Pièces DE Rechange ET Service DE Réparation Composez LE
Top Page Image Contents