Five Star Sr200na, Sr200lp,, Sr333na, Sr333lp,, Sr400na, Sr400lp To Turn OFF GAS to the Appliance

6.Turn the knob on the gas control clockwise ( ) to the black line, depress slightly, and turn to “OFF” position. See Figure 4.

Indexing Point

Gas control is shown ON.
Turn Clockwise and press	OFF
down to turn gas off.
	OFF
	ON

Gas is now OFF

You are	You are here
here
	2671 1096

FIGURE 4: Turning gas control OFF

7.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “B” in the “Before Startup” instructions (Page 4). If you don’t smell gas, go to the next step.

8.Turn the knob on the gas control counter-clockwise

( ) to the “ON” position. See Figure 5.

	Indexing Point
Gas control is shown OFF.
Turn Counter-clockwise	ON
and release to turn gas on.

11.Turn on all electric power to the appliance.

12.Press either the POOL ON or SPA ON button switches on the operating control.

13.Set the thermostat to desired setting (NOTICE: Set point must be above actual water temperature or burn- er will not fire). See OPERATING CONTROL below.

14.The blower should come on immediately, and after about 20 seconds, the burner should fire. When oper- ating for the first time, the burner may not fire on the first try because of air in the gas line. If it does not fire at first, push the OFF switch, wait five minutes, and again push the POOL or SPA ON switch. The burner should fire after about 20 seconds. You may have to repeat this until all of the air has cleared the gas line.

15.The burner should fire until the pool/spa temperature reaches the desired temperature set on the thermostat. The blower will continue to run for about 45 seconds after the burner shuts off. If any of the safety interlocks should open during burner operation, the burner shuts off immediately, but the blower continues to run for about 45 seconds.

Should overheating occur or the gas supply fail to shut off, turn off the manual gas control valve to the appliance.

16.If the appliance will not operate, follow the instruc- tions “TO TURN OFF GAS TO THE APPLIANCE”, and call your service technician or gas supplier.

TO TURN OFF GAS TO THE APPLIANCE

1.Depress OFF button on operating control.

2.Turn off all electric power to the unit.

3.Remove jacket cover(s). See Figure 3.

HEATER PARTS MAY BE HOT.

4. Turn the knob on the gas control clockwise (	) to
the black line, depress slightly, and turn to “OFF”
position. See Figure 4.

You are

here

2672 1096

ON

OFF

Gas is now ON.

You are here

5. Replace jacket cover(s).

OPERATING CONTROL

			Digital Temperature
			Display
	LOW SPEED
	BOOSTER PUMP
	HIGH SPEED
			TemperatureUp/Down
System Operation	FILTER	AUX	AUX
Indicator Lights	PUMP	1	2

FIGURE 5: Turning gas control ON

9.Replace jacket cover(s). All jacket covers must be in place when operating the appliance.

10.Set 3-way valves on inlet and outlet to pool or spa, as appropriate.

Dual Temperature

Controls

FIGURE 6: Operating Control. See Page 36 for External Control Interface.

6