Zenoah EXZ2401S manual Set up EX-RMS only, Bracket, Sweeper Assembly SE1

EX-HE

SE3

EX-HE

SE4

SE1

English

6. Set up (EX-HE only)

tighten the blade mounting bolt. (SE3)

(1)Blade mounting bolt (Left-handed)

(2)Cutter holder (B)

(3)Blade

(4)Bar

(5)Cutter holder (A)

4.Split the bracket and install the wheel assembly to the shaft tube and clamp at a position best for your job. (SE4)

(1) Bracket

English

6. Set up (EX-RMS only)

■SWEEPER ASSEMBLY (SE1)

1.Push one of the drum axles onto either of the two gearcase output shafts. If necessary, rotate the drum axle until the clevis pin hole in the axle aligns with the matching hole in the gearcase output shaft.

2.Use a clevis pin and hitch pin to secure the drum axel to the shaft.

3.Slide the recessed end of a sweeper drum assembly over the assembled axle, and then push the drum down the axel until it bottoms at the clevis pin.

(1) Clevis Pin	(2)	Hitch Pin
(3) Cotter Pin	(4)	Drum Axle
(5) Drum Assembly

IMPORTANT

The two drum assemblies are identical, but each drum must be installed with its recessed end facing toward the gearcase.

4.Use a cotter pin to secure the drum assembly on the axle (see inset) . The cotter pin is designed to fit tightly against the outboard end of the drum, so you may need to compress the drum face slightly during installation.

5.Repeat Steps 1-4 to install the remaining axle and drum assembly.

28