English
8. Operation
OP6
(5)
(6)
(4) 
(7)
OP7
OP8
5.Set the ignition switch to the “start” position. While pulling the throttle lever, push the set button, and release the throttle, then the throttle lever is in to the “start” position. (OP6)
6.While holding the unit firmly, pull out the starter rope quickly until engine fires. (OP7)
(1) | Choke lever | (2) | Close |
(3) | Open | (4) | Ignition switch |
(5) | Start | (6) | Stop |
(7) | Throttle set button |
| |
WARNING
The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to rotate as soon as the engine is started by pulling the throttle. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts. (OP8)
IMPORTANT
Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.
7.Move the choke lever downward to open the choke. And restart engine. (OP5)
8.Allow the engine to warm up for a several minutes before starting operation.
NOTE
1.When restarting the engine immediately after stopping it, leave the choke open.
2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.
■STOPPING ENGINE (OP6)
1.Release the throttle lever and run the engine for a half minute.
2.Shift the ignition switch to the STOP position.
38