Powermate PM0103002 manual Safety Information, Safety and Operation Rules

Page 3

SAFETY INFORMATION

DANGER indicates a potentially hazardous situation which, if not avoided, WILL result in death or serious injury.

WARNING indicates a

potentially hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate personal injury, or property damage.

SAFETY AND OPERATION RULES

WARNING - Failure to follow these instructions and warnings may result in death, personal injury, or property damage.

1.Read carefully and understand operator manual prior to operation of this product. Follow all warnings and instructions.

2.Know your equipment. Consider the applications, limitations, and the potential hazards specific to your unit.

3.Equipment must be placed on a firm, supporting surface.

4.Load must be kept within rating stated on generator nameplate. Overloading will damage the unit or shorten its life.

5.Engine must not be run at excessive speeds. Operating an engine at excessive speeds increases the hazard of personal injury.

Do not tamper with parts which may increase or decrease the governed speed.

6.To prevent accidental starting, always remove the spark plug or cable from the spark plug before maintaining the generator or engine.

7.Units with broken or missing parts, or without protective housing or covers, should never be operated. Contact your service center for replacement parts.

8.Units should not be operated or stored in wet or damp conditions or on highly conductive locations such as metal decking and steel work.

9.Keep the generator clean and free of oil, mud and other foreign matter.

10.Extension cords, power cords, and all electrical equipment must be in good condition. Never operate electrical equipment with damaged or defective cords.

11.Store the generator in a well ventilated area with the fuel tank empty. Fuel should not be stored near the generator.

12.Your generator should never be operated under these conditions:

a.Uncontrolled change in engine speed.

b.Electrical output loss.

c.Overheating in connected equipment.

d.Sparking.

e.Damaged receptacles.

f.Engine misfire.

g.Excessive vibration.

h.Flame or smoke.

i.Enclosed compartment.

j.Rain, snow or inclement weather. Do not let the unit get wet when operating.

13.Check the fuel system periodically for leaks or signs of deterioration such as chafed or spongy hose, loose or missing clamps, or damaged tank or cap. All defects should be corrected before operation.

14.The generator should be operated, serviced, and refueled only under the following conditions:

a.Start and run the generator outdoors. Do not run the generator in an enclosed area, even if doors or windows are open; avoid areas where vapors may be trapped, such as pits, garages, cellars, excavations and boat bilges. DANGER - CARBON MONOXIDE HAZARD: The engine exhaust contains carbon monoxide, a poisonous, odorless, invisible gas which, if breathed, may cause death or serious personal injury. If you start to feel sick, dizzy or weak while using the generator, shut it off and get to fresh air right away; you may have carbon monoxide poisoning.

b.Good ventilation for cooling. Air flow and temperatures are important for air cooled units. Temperatures should not exceed 104º F ambient (40º C).

c.Refuel the generator in a well lighted area. Avoid fuel spills and never refuel while the generator is running. Allow engine to cool for two minutes prior to refueling.

English

3

Customer Hotline 1-800-445-1805

Image 3
Contents Call US First Table of Contents Table DES MatieresIndice Safety and Operation Rules Safety InformationDetermining Total Wattage Spark ArresterOperating Voltage InstallationBefore Operation Control Panel Endbell 120 V, 20 Ampere Receptacle Generator FeaturesHandle Installation Handle InstallationApplying Load Starting the UnitPRE-START Preparation Starting the EngineService and Storage MaintenanceHOW to Order Replacement Parts Service Information Limited WarrantyRègles D’OPÉRATION ET DE Sécurité SécuritéDétermination DE LA Puissance Totale Nécessaire PARE-ÉTINCELLESVérifier LA Tension Lubrification Avant DE Mettre EN MarcheProtection Avec Disjoncteur Différentiel Gfci Mise EN Place DE LappareilCaractéristiques DU Groupe Electrogene Tableau de commande Couvre-enroulement Prise de 120 V, 20 aPose DE LA Poignée ’INSTALLATION DE PoignéeBranchement DES Appareils Demarrage DE LappareilPréparatifs AU Démarrage Démarrage DU MoteurUsage ET Entreposage EntretienService Clientele Commande DE Pièces DE RechangeGarantie Limitée Seguridad Reglas DE Seguridad Y DE FuncionamientoComo Determinar EL Vataje Total ApagachispasEL Requerimiento DE Voltaje InstalacionEL Sensor DEL Nivel Bajo DE Aceite Antes DE LA OperacionPuesta a Tierra DEL Generador LubricacionProtector de circuito Caracteristicas DEL GeneradorInstalación DE LA Manija Instalación DE LA ManijaComo Aplicar UNA Carga Arranque DEL UnidadPreparacion Antes DE Arrancar Arranque DEL MotorAlmacenamiento a Largo Plazo Servicio Y AlmacenamientoEscudo DE Calor Servicio Poco FrecuenteComo Pedir LOS Repuestos Servicio AL Cliente Garantía LimitadaCrankcase Assembly / Ensemble DU Carter / Conjunto DE Cárter Part Description Descripción QTY Part Description Descripción 0067084 Air filter cover assembly Couvercle Tapa 0067085 0067092 Muffler cover assembly Mounting Feet / Pieds DE Monter / Pies DE Montar Pramac America, LLC