Briggs & Stratton 30244 Before Starting the Engine, Add Engine Oil, Add Fuel, When Adding Fuel

Page 7

ASSEMBLY

BEFORE STARTING THE ENGINE

1.Use clean, fresh, regular UNLEADED fuel with a minimum of 87 octane. DO NOT use fuel which contains Methanol. DO NOT mix oil with fuel.

2.Clean area around fuel fill cap, remove cap.

Add Engine Oil

CAUTION! Any attempt to crank or start the engine before it has been properly serviced with the recommended oil may result in an engine failure.

1.Place generator on a flat, level surface.

2.Clean area around oil fill and remove yellow oil fill cap.

3.Using oil funnel (optional), slowly pour contents of both provided oil bottles into oil fill opening to the point of overflowing.

4.Replace oil fill cap and fully tighten.

NOTE: See the section “Oil” on page 17 to review oil recommendations.

Add Fuel

NOTE: This gasoline engine is certified to operate on

gasoline. Exhaust Emission Control System: EM (Engine Modifications).

WARNING

Fuel and its vapors are extremely flammable and explosive.

Fire or explosion can cause severe burns or death.

WHEN ADDING FUEL

Turn generator OFF and let it cool at least 2 minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank.

Fill fuel tank outdoors.

DO NOT overfill tank. Allow space for fuel expansion.

Wait for spilled fuel to evaporate before starting engine.

Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition sources.

DO NOT light a cigarette or smoke.

3.Slowly add regular unleaded fuel to fuel tank. Be careful not to fill above the baffle.This allows adequate space for fuel expansion (Figure 2).

Figure 2 — Typical Fuel Expansion Space

TANK

Baffle

FUEL

4.Install fuel cap and let any spilled fuel evaporate before starting engine.

CAUTION! Alcohol-blended fuels (called gasohol, ethanol or methanol) can attract moisture, which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

To avoid engine problems, the fuel system should be treated with a fuel preserver or emptied before storage of 30 days or longer. If adding a fuel preserver, fill the fuel tank with fresh fuel. If only partially filled, air in the tank will promote fuel deterioration during storage. If fuel preserver is not used, drain the fuel tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See “Storage” on page 22 for additional information.

NEVER use engine or carburetor cleaner products in the fuel tank as permanent damage may occur.

7

Image 7
Contents Operator’s Manual Manual del Operario Starting WattsCall Generator Helpline Llame Línea Directa del Generador Safety Rules Table of ContentsEquipment Description When Transporting or Repairing Equipment When Adding or Draining FuelWhen Starting Equipment When Operating EquipmentWhen Testing for Engine Spark When Adjusting or Making Repairs to Your GeneratorKnow Your Generator Electric Start AssemblyCheck Battery / Attach Negative Battery Wire To installAdd Fuel When Adding FuelBefore Starting the Engine Add Engine OilGenerator Location Using the GeneratorConnecting to a Building’s Electrical System System GroundStarting the Engine Operating GeneratorLow Oil Pressure Shutdown System Connecting Electrical LoadsReceptacles Stopping the Engine120/240 Volt AC, 30 Amp, Locking Receptacle Ground Fault ProtectionVolt AC, 15 Amp, Gfci Duplex Receptacles Testing the Gfci HOW to USE the Battery ChargerGenerator Adapter Cord SET Creating a Temporary Cold Weather Shelter Cold Weather OperationCreating a Permanent Cold Weather Shelter Example Power ManagementDont Overload Generator CapacityEngine Technical Information Product SpecificationsGenerator Specifications Engine SpecificationsGenerator Cleaning Generator MaintenanceGeneral Recommendations Oil Engine MaintenanceBattery Maintenance Fuel Valve MaintenanceChanging Engine Oil and Oil Filter Service Air CleanerTo clean or replace air cleaner components Adding Engine OilClean Spark Arrester Screen Clean/Replace Spark PlugClean and inspect the spark arrester as follows To adjust valve clearance Service AdjustmentsChecking/Adjusting Valve Clearance Carburetor AdjustmentsTighten Jam Nut to 175 inch-pounds 19.7 N-m Generator StorageLong Term Storage Instructions Protect Fuel SystemTroubleshooting Page Your Warranty Rights and Obligations Emissions Control Warranty Statement Emission Warranty Parts List This Warranty Shall not Apply to the Following Warranty is not TransferableLimited Warranty Advertencia Tabla DE ContenidosDescripción DEL Equipo Reglas DE SeguridadCuando Transporte O Repare EL Equipo Cuando Añada Combustible O Vacíe EL DepósitoCuando Ponga EN Funcionamiento EL Equipo Cuando Opere EL EquipoCuando Ajuste O Haga Reparaciones a SU Generador PrecauciónCuando Pruebe LA Bujía DEL Motor Tomacorriente Gfci Dobles de 120 Voltios AC, 15 Amp Conozca SU GeneradorTomacorriente con Dispositivo de Seguridad de Para instalar MontajeArranque Eléctrico Desembalaje del GeneradorCuando Añada Combustible Antes DE Darle Arranque AL MotorAgregar Aceite al Motor Agregue CombustibleUbicación del Generador USO DEL GeneradorTierra del Sistema Conexión al Sistema Eléctrico de un EdificioEncienda el Motor Operando EL GeneradorParado Del Motor Sistema DE Parada POR Baja Presion DEL AceiteReceptáculos Conexion De Cargas ElectricasVolt AC, 15 Amperios, Gfci Receptáculo Dobles 120/240 Voltios AC, 30 Amp, Receptáculo de SeguridadProtección Contra Fallos de Conexión a Tierra Cargador DE Batería Juego DE Cables DEL Adaptador DEL GeneradorComprobación del Gfci Figura 32 Clima Frío Estructura de Protección Operación Durante UN Clima FríoEjemplo No Sobrecargue GeneradorCapacidad Control de la EnergíaEspecificaciones del Generador Información Técnica Sobre EL MotorEspecificaciones DEL Producto Período de Cumplimiento del MotorMantenimiento DEL Generador Recomendaciones GeneralesLimpieza del Generador Aceite Mantenimiento DEL Motor AdvertenciaMantenimiento de la Batería Mantenimiento de la Válvula de CombustiblePara limpiar o sustituir el filtro de aire componentes Proporcione Servicio al Depurador de AireAdición de Aceite del Motor Cambio de Aceite del Motor y Filtro de AceiteLimpie la Pantalla Apagachispas Limpie/Reemplace la BujíaLimpie e inspeccione el apagachispas de la siguiente manera Ajuste de la Separación de las Válvulas Revisiones Y AjustesVelocidad del Motor Ajustes del CarburadorGenerador AlmacenamientoAlmacenamiento Para Periodos Prolongados Proteja el Sistema de CombustibleDiagnositicos DE Averías Problemo Causa AccionDerechos Y Obligaciones DE LA Garantía Garantía DE Control DE Emisiones EGR Notas Esta Garantía no SE Aplicará EN LOS Siguientes Casos Generac Power SYSTEMS, INCPlan DE Garantía Aplicaciones DE CONSUMO/COMERCIALES/INDUSTRIALESUso comercial Uso del consumidor
Related manuals
Manual 6 pages 53.09 Kb Manual 56 pages 13.11 Kb

30244 specifications

The Briggs & Stratton 30244 is a prominent portable generator designed to meet the power needs of homeowners and professionals alike. This generator stands out for its reliability, efficiency, and user-friendly features, making it a popular choice for a variety of applications, from powering essential appliances during outages to providing electricity at job sites or outdoor events.

One of the main features of the Briggs & Stratton 30244 is its impressive power output. With a maximum wattage of 7000 watts and a rated wattage of 5500 watts, this generator is capable of running multiple appliances simultaneously. Whether you need to power your refrigerator, lights, or other vital equipment during an outage, the 30244 has the capacity to handle it all. This makes it an ideal backup option for homeowners looking to maintain comfort and safety during unexpected blackouts.

The 30244 also boasts advanced technologies designed to enhance performance and fuel efficiency. It is equipped with a powerful and efficient 306cc engine, offering a balance of power and fuel consumption. This generator features a durable, low-oil shutdown system that protects the engine from damage by automatically turning it off when oil levels are low. Additionally, the generator utilizes a large-capacity fuel tank, which allows for extended run times without frequent refueling, making it convenient for prolonged power needs.

Portability is another key characteristic of the Briggs & Stratton 30244. The generator is designed with a compact and sturdy frame, complemented by a built-in handle and durable wheels, enabling easy transportation to wherever the power is needed. Whether you're moving it around the yard or loading it into a vehicle for a camping trip, its lightweight construction and thoughtful design make portability hassle-free.

Safety features are paramount in the Briggs & Stratton 30244, too. It is equipped with circuit breakers to protect against overloads, ensuring safe operation. Additionally, the generator includes a quiet design that minimizes noise, making it suitable for neighborhood use without causing disturbances.

In conclusion, the Briggs & Stratton 30244 is a versatile, powerful, and user-friendly portable generator. Its robust power output, efficient engine technology, portability, and safety features make it an excellent choice for individuals and families seeking reliable power solutions in various situations. Whether for home use or outdoor activities, this generator is designed to deliver performance and peace of mind.