Aqua Products manual Servicing Instructions, General Location of Controls

SECTION 4 / SERVICING INSTRUCTIONS

GENERAL LOCATION OF CONTROLS

	Bypass
Drain Plug	Hi Limit
	(Located
(Located in
	in Return
Return
	Header)
Header)
Ignition	AGS Hi-
	Limit
Control (IID)
	(Located
Digital	in Inlet/
	Oulet
Thermostat	Header)
Module	Unitherm
Roll-Out	Governor
Switch	Drain Plug
Gas Valve	On-Off Switch
Pilot	Transformer
	Fig #2005

CONTROL PANEL REMOVAL

1.Remove (4) screws from sides of control panel.

2.Rotate control panel down until panel stops. Do not force.

NOTE: Caution must be taken not to damage controls or wiring.

Control Panel

Mounting Screws (4)

Fig. #RP 8267

CONTROLS/ADJUSTMENTS/REPLACEMENTS

Temperature

Adjust Buttons

Mode Button

LCD Display

Fig. #2000

MILLIVOLT CONTROLS

The pool or spa water temperature is controlled by the pool heater thermostat on the upper front panel of the heater. The control center contains an On/Off switch and one or two thermostats.

Thermostats are fitted with a means of limiting the upper temperature limit below the maximum level. The knob stop adjustment ring illustrated below is adjustable by loosening the set screw, rotating the knobstop ring to the desired location and retightening the set screw.

SPA TEMPERATURE RANGE POOL TEMPERATURE RANGE

STAND-BY

TEMPRATURE

SET SCREW

KNOB STOP RING

Fig. #8103.2

KNOB STOP SHOWN ABOVE IS

IN THE SPA TEMPERATURE RANGE

24