Sanyo HF15000L owner manual Basic Operation, Turning On the Projector

Basic Operation

Turning On the Projector

1	Complete peripheral connections (with a computer, VCR,
	etc.) before turning on the projector.
2	Connect the projector’s AC power cord into an AC outlet.
	The LAMP indicator lights red and the POWER indicator
	lights green.
3	Press the ON/STAND-BY button on the side control
	or the ON button on the remote control. The LAMP
	indicator dims and the cooling fans start to operate.
	The preparation display appears on the screen and the
4	countdown starts.
	After the countdown, the input source that was selected
	the last time and the Lamp control status icon (see the

page 75) appear on the screen.

If the projector is locked with a PIN code, PIN code input dialog box will appear.

✔Note:

•When the Logo select function is set to Off, the logo will not be shown on the screen (p.66).

•When Countdown off or Off is selected in the Display function, the countdown will not be shown on the screen (p.54).

•If you press the ON/STAND-BY button on the side control or the remote control during the countdown period, you can skip the countdown and go to the normal operations. In this case, however, the brightness of the image needs some time to stabilize after turning on the projector. The display may flicker after turning on the lamps for the characteristics of the lamps. This is normal operation and not a malfunction.

16

The preparation display will disappear after 20 seconds.

Selected Input Source and Lamp control

Lamp control status

(See page 75 for Lamp control status.)

✔Note:

•The Lamp replacement icon and the Filter replacement may appear on the screen depending on the usage state of the projector.

•When the filter replacement icon keeps appearing on the screen at turning on the projector for some time and no action is taken to replace the filter, the projector will be automatically shut down in 3 minutes after turning on to protect the projector. (p.68)

•When the Picture in Picture function is set to Mode(1-5), Mode(1-5), Input source, Lamp control status, Lamp replacement icon and Filter warning icon will appear on the screen for 10 seconds.

Enter a PIN code

Use the Point ed7 8 buttons on the side control or Number buttons on the remote control to enter a number.

When using side control

Use the Point ed buttons on the side control to select a number. Press the Point 8 button to fix the number and move the red frame pointer to the next box. The number changes to ✳. Repeat this step to complete entering a four- digit number. After entering the four-digit number, move the pointer to “Set”. Press the SELECT button so that you can start to operate the projector.

When using remote control

Press the Number buttons on the remote control to enter a number (p.16). When you complete entering a four-digit number, the pointer moves to “Set”. Press the SELECT button so that you can start to operate the projector.

If you fixed an incorrect number, use the Point 7 button to move the pointer to the number you want to correct, and then enter the correct number.

If you entered an incorrect PIN code, “PIN code” and the number (✳✳✳✳) will turn red for a moment. Enter the correct PIN code all over again.

PIN Code Input Dialog Box

After the OK icon disappears, you can operate the projector.

✔Note:

•If the PIN code number is not entered within three minutes after the PIN code dialog box appeared, the projector will be turned off automatically.

•The "1234" is set as the initial PIN code at the factory.

24