Sanyo HF15000L owner manual Serial Control Interface, Example, Format

Appendix

Serial Control Interface

This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port.

Operation

1	Connect a RS-232C serial cross cable to SERIAL
	PORT IN on the projector and serial port on the PC
	(See p.11).
2	Check the communication specifications shown
	right.
3	Type a functional execution command and press the
	Enter key.

Example

To select INPUT 2 port, type “C06” [CR].

Baud rate	: 9600 / 19200 bps
Parity check	: none
Stop bit	: 1
Flow control	: none
Data bit	: 8

✔Note:

•The default of the baud rate is set to 19200 bps. If an error occurs in the communication, change the serial port and the communication speed (baud rate).

•Enter with ASCII 64-byte capital characters and one- byte characters.

Functional Execution Commands

Format

The command is sent from PC to the projector with the format below;

“C” [Command] [CR]

Command: two characters (refer to the command table below.

-The projector decodes the command and returns the “ACK” with the format below;

[ACK] [CR]

-When the projector cannot decode the command, it returns with format below.

“?” [CR]

Command	Function
C00	Turn the projector ON
C01	Turn the projector OFF
	(immediately OFF)
C05	Select Input 1
C06	Select Input 2
C07	Select Input 3
C08	Select Input 4
C0D	Video mute ON
C0E	Video mute OFF
C0F	Screen Normal Size
C10	Screen Full Size
C1C	Menu ON
C1D	Menu OFF
C3A	Pointer RIGHT

Command	Function
C3B	Pointer LEFT
C3C	Pointer UP
C3D	Pointer DOWN
C3F	Enter
C46	Zoom DOWN
C47	Zoom UP
C4A	Focus DOWN
C4B	Focus UP
C5D	Lens shift UP
C5E	Lens shift DOWN
C5F	Lens shift LEFT
C60	Lens shift RIGHT
C89	Auto PC Adj.
C8E	Keystone UP
C8F	Keystone DOWN
C90	Keystone RIGHT
C91	Keystone LEFT

98