Sanyo HF15000L owner manual Appendix, Appears on the screen

Appendix

	– The end of lamp life is approaching. Replace the lamp with a new one after it has
appears on the screen	cooled down. (See page 76)
or	– The remaining time exceeded the specified time or reached 0%. In the latter case,
	replace the filter with a new one promptly. (See pages 73, 74)
appears on the screen
	– Adjust the focus of the projector.
	– Check Projection Lens to see if it needs cleaning.
The image is out of focus.	✔Note: Moving the projector from a cool temperature location to a warm temperature
	location may result in moisture condensation on Projection Lens. In such cases,
	leave the projector OFF and wait until condensation evaporates.
	– Projecting from excessive slant angle to the screen may cause keystone distortion and
	partial imperfect focus.
	– Check if “Contrast” or “Brightness” are adjusted properly. (See pages 41, 49)
	– Check if “Image level” is selected properly. (See pages 40, 48)
The image is not bright	– Check the Lamp control function. ( See “SETTING” section on page 55)
	– Check the LAMP REPLACE indicator. If it lights, the end of lamp life is approaching.
enough.
	Replace the lamp with a new one after it has cooled down. (See page 76)
	– The image is darker when 2-lamps mode is selected, compared with 3-lamps mode.
	Check the lamp mode at SETTING section on page 55.
The color is strange.	– Check the Input signal, color system, video system, or computer system mode.
The image is Left/Right	– Check the Ceiling / Rear function. (See pages 46, 53)
reversed.
The image is Top/Bottom	– Check the Ceiling function. (See pages 46, 53)
reversed.
The image is distorted or	– Check “PC Adjust” menu or “ Screen” menu and adjust them.
runs off.
Auto PC adjustment function	– Check the Input signal. Auto PC Adjustment function cannot work when 480p, 575p,
does not work.	720p, 480i, 575i, 1035i, 1080p, or 1080i is selected or when the digital signal is input
	into HDMI/DVI-D terminal. (See page 37)
Some displays are not seen	– Check the Display function (see page 54).
during the operation.
The setting does not remain	– Make sure you selected “Store” after adjusting settings. Some settings cannot be
after turning off power.	stored if not registered with “Store”.
Power management function	– Power management function cannot work while “Freeze” function is running or the
does not work.	shutter is closed.
Image disappears	– Check the power management function in the Setting. The power management is set
automatically.	to "On" at the factory.
Capture function does not	– Check the connection to see if there is signal.
	– Capture function is not available when the Picture in Picture function is set to one of
work.
	User1 - 5.
Some menus cannot be	– Each of the Video Input and Computer Input has a limit on selectable menus.
selected.

81