Sanyo HF15000L Hdmi setup, Logo Logo and Logo PIN code lock settings, Logo select, Capture

Settings

HDMI setup

Select Normal or Enhanced according to the output signal of video equipment. Press the Point ed buttons to switch between each option.

Normal .	.	When the output of video equipment is set to
		“STANDARD.”
Enhanced	.	When the output of video equipment is set to
		“ENHANCED.”

✔Note:

•The names for the output setting of video equipment vary from equipment to equipment. For details, refer to the manual of video equipment.

Logo (Logo and Logo PIN code lock settings)

This function allows you to customize the screen logo with Logo select, Capture, Logo PIN code lock and Logo PIN code change functions.

Logo select

✔Note

When On is selected in the Logo PIN code lock function, Logo select, Capture and Logo PIN code change cannot be selected.

This function decides on the starting-up display from among following options.

User	Shows the image you captured.
Default	Shows the factory-set logo.
Off	Shows the countdown display only.

Capture

This function enables you to capture an image being projected to use it for a starting-up display or interval of presentations. Select Capture and press the SELECT button. A confirmation box appears and select Yes to capture the projected image. After capturing the projected image, go to the Logo select function and set it to User. Then the captured image will be displayed the next time you turn on the projector. To cancel the capture function, select Yes in the "Quit?" confirmation box.

✔Note

•Before capturing an image, select Standard in the Image Select Menu to capture a proper image (pp.40, 48).

•When capturing the image that has been adjusted by the Keystone function, the adjusted data is automatically reset and the projector captures an image without keystone correction.

•When Logo PIN code lock is set to On, Capture cannot be selected.

•When starting to capture a new image, the previously stored image is cleared even if you cancel the capturing.

•When there is no captured image or it is interrupted while capturing an image, User can not be selected, you can only switch between Default and Off.

•Capture function is not available when the Picture in Picture function is set to User1-5.

•When changing a PIN code, the new PIN code numbers don't appear as asteriskmarks.

Logo select

Capture

60