Sanyo HF15000L owner manual RC sensor, Power management, Timer left before Lamp is off, Direct on

Settings

RC sensor

Select a location of the infrared remote receiver of the remote control. See “Remote Control Receivers and Operating Range” on page 15 for details.

All	Activates all of the receivers
Front & Top	Activates both the front and top receivers
Top & Back	Activates both the top and back receivers
Front & Back....	Activates both the front and back receivers
Front	Activates only the front receiver.
Top	Activates only the top receiver
Back	Activates only the back receiver.

✔Note

•When placing the projector in the horizontal position, as fluorescent light may negatively affect the remote control signals, it is recommended to select either “Back” or “Front” to prevent the receiver on top of the projector from picking up the signals from the remote control.

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

Select one of the following options:

Ready	When the lamp has been fully cooled
	down, the POWER indicator changes
	to green blinking. In this condition, the
	projection lamp will be turned on if the
	input signal is reconnected or any button
	on the side control or remote control is
	pressed.
Shut down	When the lamp has been fully cooled
	down, the power will be turned off.
Off	Power management function is off.
Timer	If the input signal is interrupted and
	no button is pressed for more than 30
	seconds, the timer display with No signal
	appears. It starts the countdown until
	the lamp is turned off. Use the Point ed
	buttons to set the Timer(1~30Min).

✔Note

•Factory default is Ready: 5 Min.

•When the shutter is closed while the Power management function is working, the Power management function is released.

No signal

4 : 50

Timer left before Lamp is off.

Direct on

When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to the wall outlet.

✔Note

•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 25). If the projector is turned off in the incorrect sequence, the "Direct on" function does not work properly.

63