Hitachi CP-X600 user manual Input Menu, Progressive, 3D-YCS, Color Space

INPUT Menu

INPUT Menu

From the INPUT menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table.

/'07=4)$?	5'.'%6
2+%674'		
	241)4'55+8'68
+/#)'	8+&'104/+&
+0276	&;%556+..
5'672	%1.1452#%'#761
#7&+1	%1/210'06%1/210'06
	8+&'1(14/#6#761
5%4''0
	
126+10	(4#/'.1%-674010
	4)$+0
'#5;/'07
	4'51.76+10

Item

Description

	Using the ▲/▼ buttons switches the progress mode.
	TV ó FILM ó TURN OFF
	• This function is performed only for an interlaced signal of a VIDEO
	input, an S-VIDEO input or COMPONENT VIDEO input of 525i
PROGRESSIVE	(480i), 625i (576i) or 1125i (1080i) signal.
	• When TV or FILM is selected, the screen image will be sharp.
	FILM adapts to the 2-3 Pull-Down conversion system. But these
	may cause a certain defect (for example, jagged line) of the picture
	for a quick moving object. In such a case, please select TURN OFF,
	even though the screen image may lose the sharpness.
	Using the ▲/▼ buttons switches the noise reduction mode.
	HIGH ó MID ó LOW

•This function performs only at a VIDEO input, an S-VIDEO or

VIDEO NR COMPONENT VIDEO input of 525i(480i), 625i(576i) or 1125i (1080i) signal.

•When this function is excessive, it may cause a certain degradation of the picture.

	Using the ▲/▼ buttons switches the 3D-YCS mode.
	STILL ó MOVIE ó TURN OFF
3D-YCS	• This function performs only at a VIDEO input of NTSC, and PAL.
	• MOVIE is the mode for images with a lot of motions like movies,
	and STILL is the mode for images with few motions or completely
	still ones like slides.
	Using the ▲/▼ buttons switches the mode for color space.
	AUTO ó RGB ó SMPTE240 ó REC709 ó REC601
COLOR SPACE	• This item can be selected only for an RGB signal or a component
	video signal (except 525i (480i), 625i (576i) and SCART RGB).
	• The AUTO mode automatically selects the optimum mode.
	• The AUTO operation may not work well at some signals. In such a
	case, it might be good to select a suitable mode except AUTO.

(continued on next page)

30