Kodak 8650 manual Working with the printer settings, Printer settings

Operating the printer

Working with the printer settings

You view and change the printer settings using the printer's Setup mode.

Table 3-1 lists the printer settings and options, and describes each option. It also shows the factory default for each setting.

Table 3-1.Printer settings

setting	options	description	factory
			default
Mode (set-	PostScript and Raster	Specifies which mode the printer is operat-	Postscript
ting avail-		ing in.
able ONLY		WARNING: When an external hard drive
if the print-		is connected to a computer, you MUST
er can op-		disconnect the SCSI cable before
erate in		switching from raster to PostScript
both		mode. Otherwise, the hard drive may be
modes)		damaged.
Port	Mode - Normal and	Determines whether the parallel port will ac-	Normal
(Parallel)	Binary	cept data in normal PostScript or Adobe bi-
		nary mode. In normal mode, only printable
		characters are accepted; characters in high
		ASCII range (128-255) are not accepted.
		Binary mode support high ASCII range; full
		eight-bit data may be sent.
Port	Version 2 and Version 1	Determines whether Version 1 or Version 2	Version 2
(Ethertalk)		of AppleTalk will be supported.
Port	802.2, 802.3, SNAP,	Specifies the framing type the printer should	AUTO-
(IPX)	ETHERNET 2,	expect.	SELECT
	AUTOSELECT
Port	fill in IP Address in follow-	Sets up the Internet address of the printer	no default
(TCP/IP)	ing format:	within a TCP/IP network.
	nnn.nnn.nnn.nnn

3-4 October 1997