Operating the printer
Working in Setup mode
To enter Setup mode: Press Setup/Select while the printer is idle.
To scroll through the settings: Press Print to scroll up, Cancel to scroll down. You scroll through the settings continuously.
To select an option: When you find the setting whose options you wish to view, press Setup/Select. An asterisk (*) next to an option means it is selected.
To exit Setup mode: Select SETUP:EXIT. Most changes you make are effective as soon as you exit Setup mode. The exceptions are when you return the settings to the factory defaults, and when you change the printer's operating mode. In these cases, the printer restarts itself when you exit Setup mode. Changes are effective immediately afterward.
To restore the printer settings to their factory settings: Press Setup/ Select when SETUP:DEFAULTS appears. Select FACTORY:RESET to restore all the printer settings to their factory settings.
IMPORTANT: If the Network Interface Card is installed, restoring the settings to their factory values may cause network printing problems.
About specifying port information
The options you select must match your host computer settings.
There are different submenus associated with the PORTS menu. Which ones are available depends on whether the printer is running in Raster or PostScript mode, and on whether the Network Interface Card is installed.
October 1997 |