FARGO electronic Card Printer manual ~1%JULIE ANDERSON623-85-1253?

4250/4225 Card Printer UserÕs Manual

magnetic track data in order for the printer driver to know which data is to be encoded, which tracks to encode, when the track data stops and starts, and so forth. In some cases, these specific characters are automatically added to the string of track data by customized ID software applications. In most cases, however, the user must manually add these characters to the string of magnetic track data. If these characters are not added to the track data, the text intended for the magnetic track will most likely appear as printed text on the card. To avoid this, track information must be entered as follows.

When entering track data, the Ò~Ó character is entered first, followed by the track number (1, 2, or 3) on which you intend to encode the data. The data to be encoded should then follow. The first character of this data string must be the trackÕs specific Start Sentinel (SS) and the last character must be the specific End Sentinel (ES). The characters or data in between the SS and ES can include all of the valid characters specific to each track. The number of these characters, however, is limited by each trackÕs maximum character capacity. When segmenting track data, the appropriate Field Separator (FS) must be used. The following table shows the SS, ES, FS, and the valid characters defined for each track.

					Maximum
	Start	End	Field		Number of
	Sentinel	Sentinel	Separator	Valid Characters	Characters
Track 1	%	?	^	0-9, A-Z, Punct. (ASCII 32-95)	78
Track 2	;	?	=	0-9, ;, =, ? (ASCII 48-63)	39
Track 3	;	?	=	0-9, ;, =, ? (ASCII 48-63)	106

The following example illustrates how track data should be entered for tracks 1, 2, and 3:

Example:	Sending data to Track 1
	~1%JULIE ANDERSON^623-85-1253?
	Sending data to Track 2
	~2;0123456789?
	Sending data to Track 3
	~3;0123456789?

Appendix A: Magnetic Stripe Encoding Module

77