Emerson IS-WEB485ADPT installation manual Boot/IP Settings, Boot/IP settings range

Network Settings

5.1Boot/IP Settings

The Boot/IP Settings Menu is used to set parameters for network access to the Web card. Consult your network administrator for these settings.

Terminal Emulation (Serial or TCP/IP Connection) / Telnet

To change any parameter:

Boot/IP Settings Menu

----------------------

1: Speed/Duplex	Auto
2: Boot mode	Static
3: IP Address	192.168.0.125
4: Netmask	255.255.255.0
5: Default Gateway	192.168.0.1
6: DNS Server	0.0.0.0

<ESC>: Cancel menu level Please select a key ?>

1.Choose IP Network Settings from the Main Menu, then Boot/IP Settings.

2.Select an option to change—for example, Speed/Duplex, then enter settings according to the following guide.

Table 9	Boot/IP settings range
Parameter			Description & Valid Settings*
		Speed and duplex configuration of the Ethernet port.
Speed/ Duplex		• Auto (default—use this setting if unknown)
		• 10Mbs/Half Duplex	• 100Mbs/Half Duplex
		• 10Mbs/Full Duplex	• 100Mbs/Full Duplex
		Startup mode enabling the Web card to be a network-ready device.
Boot Mode		• Static - Fixed network addresses and other parameters
		• DHCP - Central management using dynamic network addresses
		• BootP - Older mechanism for central management of network addresses
IP address		Network address for the Liebert unit.
		Four numbers (0-255) separated by periods (.)—for example, 10.0.0.5
Netmask		Network mask that divides your network into manageable segments.
		Four numbers (0-255) separated by periods (.)—e.g., 255.255.255.0
Default Gateway		IP address of the gateway for network traffic to other networks or subnets.
		Four numbers (0-255) separated by periods (.)—e.g., 10.0.0.1
DHCP/BootP Server		Device on a network that assigns IP addresses that are not static.
		Four numbers (0-255) separated by periods (.)—for example, 192.168.0.5
DNS Server		IP address of the Domain Name Server for the network.
		Four numbers (0-255) separated by periods (.)—e.g., 10.0.0.1

* Consult your network administrator for proper settings.

Web Interface

To access Boot/IP Settings through the Web interface:

•Click on the Configure tab, then Network Settings in the left panel and finally Edit beneath the table of parameters and descriptions. After making changes, click Save.

Configure tab

Network

Settings

Edit

13