Emerson IS-WEB485ADPT installation manual Open the Terminal Emulation Interface Serial Connection

Connect to the Card - Terminal Emulation, Telnet or Web Interface

A.2 CONNECT TO THE CARD - TERMINAL EMULATION, TELNET OR WEB INTERFACE

Upgrading the firmware requires connecting to the card with one of these interfaces.

A.2.1 Open the Terminal Emulation Interface - Serial Connection

To connect to the card using terminal emulation software with a
serial connection to the Web card:
1. Open a terminal emulation application, such as	Name
HyperTerminal.
To do this:

•Click the Start button, then Programs, Accessories, Communications and finally HyperTerminal.

2.In the Connection Description window, enter a name for the connection—for example, GXT2U—then click OK.

3.In the Connect To window:

•Choose COM3 from the Connect Using drop-down list.

•Click OK.

4.In the COM3 Properties window, enter the communication settings shown in Table A3.

Table A3 Communication settings

Baud Rate:	9600
Data Bits:	8
Parity:	None
Stop Bits:	1
Flow Control:	None

5.When the message at right appears in the HyperTerminal window, press the Enter key.

COM3

Connection settings

A.2.2 Open the Terminal Emulation Interface - TCP/IP Connection

To connect to the card using terminal emulation software with
an Ethernet connection to the Web card:
1. Open a terminal emulation application, such as	Name
HyperTerminal.
To do this:

•Click the Start button, then Programs, Accessories, Communications and finally HyperTerminal.

2.In the Connection Description window, enter a name for the connection—for example, GXT2U—then click OK.

3.In the Connect To window:

•Choose TCP/IP (Winsock) from the Connect Using drop-down list.

•Enter the IP address of the Web card—for example, 192.168.0.125—in the Host Address box, then click OK.

TCP/IP

(Winsock)

4.When the message at right appears in the HyperTerminal window, press the Enter key.

5.Enter the Administrator username and password (both are case- sensitive):

a.Login (username—default is Liebert)

b.Password (default is Liebert)

RTCS v2.96.00 Telnet server

Service Port Manager Active <Esc> Ends Session

Login: Liebert

Password: ********

A2