Emerson IS-WEB485ADPT installation manual Controlling Liebert Equipment

Monitor and Control Functions - Web Only

8.2Controlling Liebert Equipment

To perform Control operations through the Web interface:

•Open the Web interface (if needed, see 3.5 - Open the Web Interface).

•Click on the Control tab, as shown in the following example.

Control tab

Control Operations Click to view in right panel

•Control Operations categories appear at bottom left, organized with folder icons and showing the available Control functions. Clicking on a category changes the view in the right panel. The example above shows the summary page.

The following guide is a partial list of Control operations—these vary by the type of Liebert unit.

Table 23 Control operations parameters—functions vary by Liebert unit

Command	Description
Abort Commands	Prevent any pending commands from being completed.
Alarm Silence / Alarms	Temporarily silence an audible alarm that is active. Reset or acknowledge alarms
Output / System	Turn the Liebert unit On or Off; reboot the unit.
Statistics	Reset statistics—for example, battery or power statistics
Tests	Initiate diagnostic tests on the Liebert unit.
Setpoints	Change setpoints for the Liebert unit.

•To perform an operation, click on a Control Operations category at left, then click on the appropri- ate button in the right panel. The example below shows control operations for two Liebert units.

Liebert GXT2U example

Output

Liebert

DS example

Setpoints

37