Emerson Understanding Default Passwords and Liebert DS Passwords

Network Settings

5.8Reset Authentication to Factory Defaults

You may reset the Administrator and General User usernames and passwords to the factory defaults.

If you forget your username or password, you may reset them using a serial configuration cable connection (see Section 2.1.1 or 2.2.1 - Connect the Cable), which provides direct access to the card without a username or password. To enter a new username and password, see 5.7 - Change Username / Password.

Table 17 Factory default passwords

Type of User	Factory Default		Description
Administrator	Username	Liebert	Full access to configuration and control
	Password	Liebert	functions, as well as viewing privileges
General User	Username	User	Viewing privileges only—no access to
	Password	User	configuration or control functions

Terminal Emulation (Serial or TCP/IP Connection) / Telnet

To reset the usernames and passwords to the factory defaults:

1.Choose IP Network Settings from the Main Menu, then Reset Authentication to Factory Defaults.

Reset authentication to factory Defaults? [y/n] ?>

2.Enter y to reset the Administrator and General User usernames and passwords to the default settings.

NOTE

This feature is not available through the Web interface

27