Support Information
9.2Events and Parameters
You may view a list of all supported events and parameters for the Liebert equipment through any interface. Depending on the Liebert IntelliSlot Web card, the list might include SNMP and Modbus.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To view this data:
•Choose IP Network Settings from the Main Menu.
•Choose Management Protocol, then SNMP Communica- tions.
•Choose Support Information from the SNMP Communica- tions Menu to display the menu at right.
The menu displays:
•the number of events
•the number of parameters
•the total number of objects (sum of events and parameters)
•Choose Display Events to view a list of supported events for the Liebert unit, as shown in the example at right.
These events may vary according to the Liebert unit where the card is installed.
•Choose Display Parameters to view a list of supported param- eters for the Liebert unit, as in the example at right.
These parameters vary according to the Liebert unit where the card is installed.
SNMP Communications Menu
1:Authentication Traps 'no'
2:Display/Modify Communities
3:Display/Modify Trap Communities
4:Support Information
<ESC>: Cancel menu level Please select a key ?>
Support Information Menu
1:Display Events
2:Display Parameters
Total Events: 40
Total Parameters: 141
Total Objects: 181
<ESC>: Cancel menu level Please select a key ?>
Display Events (Example)
AlarmOnBypass,1.3.6.1.2.1.33.
1.6.3.9
lgpAgentDeviceCommunicationLost,
1.3.6.1.4.1.476.1.42.2.3.0.1 Hit any key to continue...
Display Parameters (Example)
sysDescr,1.3.6.1.2.1.1.1.0
sysObjectID,1.3.6.1.2.1.1.2.0 Hit any key to continue...
Web Interface
To view events and parameters through the Web interface:
•Click on the Support tab, then Events (or Parameters) in the left panel. The events or parame- ters are listed in the right panel. The example below shows a list of Events.
Support tab
Listing in right panel
Events (or
Parameters)
40